STEP #4
Installing the Cooktop
There are two mounting brackets supplied with the glass ceramic cooktop. These brackets are
designed to hold the cooktop firmly in place. The cooktop does not have a metal frame and
should be bedded to the countertop using a soft bedding compound that will prevent damage if
later removal for service is necessary. We recommend a very small bead of silicone sealant. If
mounting in granite countertop use only 100% silicone sealant.
Attach the two mounting brackets supplied with the KENYON cooktop (please refer to the figure
C on page 8) to the inside vertical surface of the cutout. The brackets are to be mounted on op-
posing sides. Center the bracket in the opening, flush with the countertop and secure with long
self-tapping screws that are provided. Position the cooktop in the cutout opening and press firmly
on all sides to seal the frame into the bedding compound. Secure the cooktop to the
brackets from underneath with the small sheet metal screws that are supplied.
BE CAREFUL NOT TO OVERTIGHTEN THE SCREWS.
STEP #5
Electrical Connection
Before proceeding further, verify that the power
supply is disconnected. Verify that the
appropriate electrical supply requirements have
been met. Please refer to the table on page
5 for appropriate electrical requirements. The
cooktop is supplied with a 36-inch long
conduit for a connection to an accessible
junction box. The 240V and 208V conduit
consists of three insulated wires. There are
two insulated hot lead conductors (red and
black) and one insulated ground conductor
(green). The 120V conduit consists of three
insulated wires. There is the hot lead
conductor (black), the nuetral conductor (white)
and one insulated ground conductor (green).
Attach conductor wires to residence wiring in
accordance with national, state and local
electric codes.
Lite-Touch™ Q COOKTOP
# 8 X 1/4" SCREW
# 6 X 1 1/4" S/S SCREW
MOUNTING BRACKET
COUNTER SURFACE
Fig. C
9
