Kenwood VR-9060, Инструкция по эксплуатации

Страница: 46 / 48

46
EN
Remote control unit
Cause
• No setup codes registered for the respective
input(s).
• The remote control unit is set to a different
operation mode.
• Batteries are exhausted.
• The remote control unit is too far away from
the main system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.
• No disc or tape is placed in the source
component.
• An attempt is made to play a tape which is
being recorded in the cassette deck.
• The remote control has not been set to the
operation mode for the component you wish
to control.
Remedy
• Register a setup code at the respective input(s).
›
• Press the RCV MODE key to select the
appropriate operation mode.
• Replace with new batteries.
• Operate the remote control unit within the
controllable range.
• Place the disc or tape in the source component
which you want to play.
• Wait until recording has completed.
• Press any of the Source keys or SOURCE
key to activate the operation mode for the
component you want to control before
operation.
›
Symptom
Certain inputs cannot be selected using the
remote control.
Remote control operation is not possible.
In case of difficulty
*5551/34-48/EN
05.2.7, 6:25 PM 46