Kenwood TM-D700A, Инструкция по эксплуатации

Страница: 14 / 55

11
4
y
Access Menu 3–8 to select your station icon {page 18}.
u
Access Menu 3–4 to program position data {page 19}.
i
Access Menu 3–6 to select from 15 position
comments {page 20}.
o
If you want, access Menu 3–9 to enter status text
using up to 28 alphanumeric characters {page 21}.
!0
Access Menu 3–C to select the operation method
for transmitting packets {page 25}.
!1
Press [F] (1 s), [BCON]. If you selected “PTT” in
step
!0
, then press and release Mic [PTT] {page 25}.
q
Access Menu 3–I to select band A or B as the data
band {page 13}. The default is band A.
w
Press [F] (1 s), [TNC] to enter APRS mode.
• “TNC APRS” should appear.
e
On the data band, select the same frequency as
other stations in your group.
• You may tune to the frequency of an appropriate
digipeater network (144.390 MHz in the U.S.) {page 9}.
r
Access Menu 3–1 to program your call sign
(9 digits max.) {page 17}.
t
If you have connected a GPS receiver, access Menu
3–2 and select “NMEA” or “NMEA96” {page 10}.
The default is “NOT USED”.
OPERATION FLOW
The following flow chart includes only the steps to give
APRS a quick try.
Now you are ready to receive APRS packets from
other stations. Refer to “RECEIVING APRS DATA”
{page 14}. To transmit your APRS packet, proceed to
step
r
.
When using a personal computer, press [F] (1 s), [TNC],
then [F] (1 s), [TNC] again in step
w
to enter Packet
mode; “TNC PKT” should appear. All further operations
should be performed on your computer.
Menu Set-up allows you to change various default
settings for APRS operations. See the appropriate
sections in this chapter.