2
TK-480
GENERAL / SYSTEM SET-UP
INTRODUCTION
SCOPE OF THIS MANUAL
This manual is intended for use by experienced techni-
cians familiar with similar types of commercial grade com-
munications equipment. It contains all required service in-
formation for the equipment and is current as of this publica-
tion date. Changes which may occur after publication are
covered by either Service Bulletins or Manual Revisions,
which are issued as required.
ORDERING REPLACEMENT PARTS
When ordering replacement parts or equipment informa-
tion, the full part identification number should be included.
This applies to all parts : components, kits, and chassis. If
the part number is not known, include the chassis or kit
number of which it is a part and a sufficient description of
the required component, for proper identification.
PERSONNEL SAFETY
The following precautions are recommended for person-
nel safety :
• DO NOT transmit until all RF connectors are secure and
any open connectors are properly terminated.
• SHUT OFF this equipment when near electrical blasting
caps or while in an explosive atmosphere.
• This equipment should be serviced by only qualified tech-
nicians.
SERVICE
This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and align-
ment procedures contained within.
Model &
Unit
Frequency range
Remarks
Charger
Battery
12 key
destination
TX-RX unit
DISPLAY unit
TK-480
M2
X57-5630-10
X54-3210-11
806~870MHz
IF1 : 44.85MHz
Option
✓
✓
LOC : 44.395MHz
Note
: X57-5630-10/X54-3210-11 : Produced in Singapore
Merchandise received
Choose the type of transceiver
Transceiver programming
Are you using the speaker microphone?
Delivery
TX
806~825
2.5W
TK-480 M2
851~870
RX
851~870
Frequency range (MHz) RF power
Type
A personal computer (IBM PC or compatible), programming
interface (KPG-36), and programming software (KPG-49D (M2)
ver 6.30 or later) are required for programming.
(The frequency, trunked system features, conventional system
features, TX power HI/LOW, and signaling data are programmed
for the transceiver.)
YES
NO
KMC-25
Speaker microphone
(Option)
SYSTEM SET-UP
