TK-2202L
4
4. Clone Mode
4-1. Outline
"Clone Mode" copies the transceiver data to another
transceiver.
The dealer can copy the transceiver data to another
transceiver even without the use of a personal computer.
4-2. Example
The transceiver can copy the programming data to one or
more transceivers via RF communication.
The clone source and clone target/s must be in Clone mode.
4-3. Operation
1. To switch the clone target/s to Clone mode, press and hold the
[PTT] and [Side2] keys while turning the transceiver power ON.
2. Wait for 2 seconds. The LED will light orange and the
transceiver will announce "Clone".
3. Select a channel table number using Side1(increment
channel table) and Side2(decrement channnel table) keys.
4. To switch the clone source to Clone mode, press and hold the
[PTT] and [Side2] keys while turning the transceiver power ON.
5. Wait for 2 seconds. The LED will light orange and the
transceiver will announce "Clone".
6. Select the same channel table number as the clone target/s.
7. Press [PTT] on the clone source to begin data transmission.
When the clone target starts to receive data, the LED will
light green.
When the clone source finishes sending data, a
"confirmation" tone will sound.
If data transmission fails while cloning, an "error" tone will
sound from the Target unit.
8. If the cloning fails, no data will be available in the Target
unit when it is returned to User mode.
9. When the cloning is successful, the Target unit's "Scan"
and "Key lock" functions will return to their default values
(Scan = OFF, Key lock = OFF).
Notes:
•
The dealer can clone data to two or more transceivers by
repeating the above procedures.
•
If the transceivers Clone Mode is configured as "Disabled",
the transceiver cannot enter Clone mode.
•
The table shown below will cover the frequency tables used
for wireless cloning.
•
Clone mode cannot be entered in battery low state.
•
A unit cannot be a "Source Unit" if it is unprogrammed. If
[PTT] is pressed, an "error" tone will sound.
•
The language used in cloning depends on the FPU setting.
•
Once a unit is set to be the Source, it cannot be a target
after the data has been transmitted. This protects the data
in the Source unit.
•
Electronic interface may cause a failure in data transfer
during Wireless Clone, such as when waveforms or
electromagnetics are being performed at the workbench.
REALIGNMENT
•
Clone mode can be used ONLY by the authorized service
personnel.
•
The Clone mode setting must be configured as "Disable"
before being delivered to the end-user.
•
To clone, replace the antenna from both the source
transceiver and the target transceiver with a dummy load.
•
The transmit output power is automatically set to Low
in Clone mode.
Clone Frequency Table
Operating Frequency
Clone
(MHz)
136~174
Frequency Table
1
136.000
2
138.000
3
140.000
4
142.000
5
144.000
6
146.000
7
148.000
8
150.000
9
152.000
10
154.000
11
156.000
12
158.000
13
160.000
14
162.000
15
164.000
16
166.000
17
168.000
18
170.000
19
172.000
20
174.000
