SPECIFICATIONS
FREQUENCY CHARACTERISTICS (STANDARD WAVEFORMS)
Sine
10
μ
Hz
to 31 MHz
Square
10
μ
Hz
to 31 MHz
Triangle, Ramp
10
μ
Hz
to 500 kHz
Accuracy
0.0025 %
(25 ppm)
Resolution
10 digits or 1
μ
Hz
ARBITRARY CHARACTERISTICS
Waveform length
2 points
to 500,000 points
Vertical resolution
12 bits
Sampling rate
20ns
to 50s
Accuracy
0.0025 %
(25ppm)
Resolution
4 digits or 10 ps
OUTPUT CHARACTERISTICS ( into 50ohms)
Amplitude Range
10mV
to 10Vp-p
Resolution
3 digits (1000 counts)
Amplitude Accuracy
± 1.25% ± 20mV (Amplitude: 1V to 10V)
± 2.5% ± 10mV (Amplitude: 10mV to 999mV)
Flatness(Sine)
0.1 dB at 10MHz
1 dB at 20 MHz
2 dB at 31 MHz
Offset Range
± 4.5V into 50 ohms, depending on the Amplitude setting
Offset Resolution
10 mV (Amplitude >= 1V)
1 mV (Amplitude < 1V)
Offset Accuracy
± 1.25% ± 20mV (Amplitude: 1V to 10V)
± 2.5% ± 2mV (Amplitude: 10mV to 999mV)
Output Impedance
50 ohm
Output Protection
The main output is protected against short circuit.
WAVEFORM CHARACTERISTICS
Harmonic Distortion
0
to 100 kHz: -55 dBc
100 kHz
to 1 MHz: -45 dBc
1 MHz
to 15 MHz: -35 dBc
15 MHz
to 31 MHz: -25 dBc
Spurious
DC
to 1MHz: <-65 dBc
1MHz
to 31MHz
＜
-50dBc
Square Rise/Fall
< 12 ns (10% to 90%) at full amplitude into 50 ohms
Variable Duty Cycle
Square :20% to 80% to 5 MHz, 40% to 60% up to 20MHz
Triangle: 10% to 90% to 500kHz
Symmetry at 50%
< 1 % ( < 5MHz)
OPERATING MODES
Continuous
Output continuous at programmed parameters.
Triggered
Output quiescent until triggered by an internal or external
trigger, then one waveform cycle is generated to programmed
parameters.
The
trigger
is
a
rising
edge.
Up to 10MHz trig rate for ARB waveforms and 5 MHz in DDS
Gate
Same as triggered mode, except waveform is executed for the
duration of the gate signal. (The
gate
signal
is
high
level.)
Burst
2
to 99,999 cycles
Phase
-360° to +360°, 0.1° resolution
Trigger Source
Trigger source may be internal, external or manual.
Internal trigger rate 0.01Hz-1MHz
MODULATION CHARACTERISTICS
Amplitude
Modulation
Internal:
0.01Hz-20KHz sine, square or triangle waveform
Variable modulation from 0% to 100%.
External:
5 Vp-p for 100% modulation, 10 kohms input imped-
ance.
Frequency
Modulation
Internal:
0.01Hz-20KHz sine wave, square or triangle
External:
5 Vp-p for 100% deviation, 10 kohms input impedance.
FSK
Internal rate
0.02Hz-1MHz
External
1MHz max
SWEEP CHARACTERISTICS
Sweep Shape
Linear and Logarithmic, up or down
Sweep Time
100 ms
to 500 s.
Sweep trigger
internal, external, continuous or burst
VARIABLE PHASE
Range
+360
°
to –360
°
Resolution
0.1
°
INPUTS AND OUTPUTS
Trigger In
TTL compatible.
Max. rate:
10MHz
(
Arb),
5MHz(DDS)
.
Minimum width: 50ns.
Sync Out
TTL pulse at programmed frequency, 50 ohms source
impedance.
Modulation IN
5 Vp-p for 100% modulation.
10 kohms input impedance.
DC to >20 KHz minimum bandwidth.
Note: When FSK modulation, the external input
connector
is
“
Trigger IN” connector.
Reference IN-OUT
10 MHz, TTL compatible, input or output, for external
unit synchronization.
GENERAL
Store memory
50 full panel settings at power-off
Arbitrary memory
500K points in flash memory
Dimensions
W: 213 mm x H: 88 mm x D: 300 mm
Weight
Aprox 3 kg
Interface
RS-232
A DB 9-pin male DTE RS-232 interface
GP-IB
Fully programmable with IEEE488.2 compliance
Power Source
Line Voltage Range
100V
to 240V
／
47Hz
to 63Hz
Power Consumption
40
VA
max
Fuse Rating
T1A, 250V
Atmospherics
Ambient
Tempera-
ture
Within
Specifica-
10ºC
to 35ºC
Operating
0ºC
to 50ºC
Storage
-10ºC
to 60ºC
Relative Humidity
90 % RH, 10ºC
to 30ºC
Regulation(CE Labeled)
SAFETY
EN61010
EN55011
、
EN55082
Accessories
Accessories
Instruction Manual (CD-R), AC cable
EMC
[KENWOOD TMI HOME PAGE] http://www.kenwoodtmi.co.jp
●For safe and correct use, please read the instruction manual and cautions on safe before using the product.
●Please do not install and use the product at the place where is near water, under high humidity, a lot of steam, dust, lamp soot, etc.
(Those may cause fire, electric shock, breakdown, etc. )
●Specifications and design are subject to change without notice.●The color of this catalog may differ from the original due to limitation of photo and printing technique.
1850-1, Tsuruma Machida-shi, Tokyo, 194-0004 Japan
Phone: 81-42-788-4823 Fax: 81-42-788-4825
