Kenwood ProTalk NX-P500, Руководство пользователя

Страница: 34 / 68

34
SCAN
Scan is useful for monitoring signals on the transceiver channels. When scanning,
the transceiver checks for a signal on each channel and only stops if a signal is
present.
If the QT/ DQT/ RAN matches, the transceiver stops at the channel and opens the
squelch so you can listen to the call. If the QT/ DQT/ RAN does not match, the call
is ignored and scanning continues.
Before you can use the scan function, ensure that it is activated. You can turn the
scan function (the ability to perform scan) ON or OFF in Setting mode.
SCAN BUTTON SETUP
You can set up the transceiver Side button or Menu button to perform SCAN
functions.
SCAN: Press this button to start scanning the transceiver channels.
Scan Delete/ Add:
Adds or removes the selected Channel to or from the scan
sequence.
To set up the
SCAN
button:
1
Enter the Setting mode {p.37}.
2
Press the or button to select “
”(Side)or “ ” (Menu).
3
Press the Menu button then press or button to select
“ ”.
SCAN OPERATION
To begin scanning:
1
To begin scanning, press the button set for scan.
• The indicator appears on the display.
• The channels are scanned.
2
When the signal is detected and the QT/ DQT/ RAN
matches, the channel number is displayed on the display
and the SCAN icon blinks.
3
When the signal is no longer present, the transceiver waits
for 3 seconds before scanning continues.
• If a new signal appears before the 3 seconds elapse,
the transceiver will remain on the channel until the new
signal is no longer present, at which time it will again
wait for 3 seconds before continuing.