Kenwood NX-840, Руководство по обслуживанию

Страница: 6 / 54

1-6 (No.RA011<Rev.001>)
2.2.4.2 Flow chart (Source transceiver)
2.3 INSTALLATION
2.3.1 Connection Cable (KCT-60: Option)
The KCT-60 connection cable kit is used to connect the trans-
ceiver to a Horn alert cable, KCT-18 (Ignition sense cable), KES-
5 (External speaker), or through the KCT-36 extension cable.
2.3.1.1 Installing the KCT-60 (Connection cable) in the
transceiver
(1) Remove the ACC. cap on the rear of the transceiver.
(2) Connect the D-sub connector of the KCT-60 to the D-sub
15-pin terminal of the transceiver.
(3) Connect the 15-pin connector of the KCT-60 to a Horn alert
cable, KCT-18, KES-5, or through a KCT-36 extension ca-
ble.
Note:
You must set up using the KPG-175D.
2.3.1.2 Terminal function
2.3.2 Horn Alert Function
The Horn alert function (max. 2A drive) is enabled by installing
the KCT-60 in the transceiver.
2.3.2.1 Installation Procedure
(1) Remove the ACC. cap on the rear of the transceiver.
(2) Connect the D-sub connector of the KCT-60 to the D-sub
15-pin terminal of the transceiver.
(3) Insert the two crimp terminals of the Horn alert cable to pins
13 and 14 of the square plug.
(4) Connect the square plug to the 15-pin connector of the
KCT-60.
(5) Connect the remaining two Horn alert cables to your car
Horn alert signal control.
The internal FET switch can be controlled by turning the HA
function on/off and by using a signaling decode output. The
maximum current of HA is 2A. This FET switch is the open
drain circuit. Therefore, a DC power supply is necessary to
use the HR1. The voltage range is from 5V to 16V.
D-sub 15-pin Pin No. Name Molex 15-pin Pin No.
1 SB 1
2 IGN 2
3 PA or
External SP
12
4 DETO 4
5 DATAI 5
Press [ ] key + Power ON for 2 seconds
Is
password*
set?
* Read
Authorization
password
Shows PS
Yes
Yes
[ ]
No
No
Clone mode
Enter password
Start the clone funnction
Is entered
password
correct?
Horn alert cable, KCT-18,
KES-5 or through KCT-36
extension cable
KCT-60
6 FNC1 9
7 FNC2 11
8 FNC3 7
9 FNC4 6
10 FNC5 8
11 FNC6 10
12 5MS NC
13 HR1 13
14 HR2 14
15 GND 3
D-sub 15-pin Pin No. Name Molex 15-pin Pin No.
13. HR1
14. HR2
More
than 8
1. SB
3. GND
13. HR1
14. HR2
More
than 8
1. SB
3. GND
13. HR1
14. HR2
3. GND
(Default)
13
14
Horn alert cable
Square plug
Crimp terminal
13
14
15
10
11
12
7
8
9
4
5
6
1
2
3
KCT-60