Kenwood NEXEDGE NX-900, Руководство по обслуживанию, Страница: 8 / 115

NX-900
8
2. Horn Alert/P.A. Relay Unit (KAP-2: Option)
The Horn alert (max. 2A drive), Public address and Exter-
nal speaker function are enabled by installing the KAP-2 in
the transceiver.
2-1. Installing the KAP-2 unit in the transceiver
(The kit A is not used in the KAP-2 accessories)
1. Remove the cabinet, top packing and shielding plate of
the transceiver.
2. Set the KAP-2 relay unit jumper pins according to the
purpose of use.
3. Remove the 6-pin jumper connector inserted in the TX-
RX unit (A/2) connector (CN705). (
q
)
4. Insert one side of the lead wire with connector (E37-
1114-05) into the relay unit connector (CN3) (
w
) and the
other side into the TX-RX unit (A/2) connector (CN705)
(
e
).
5. Place the relay unit at the position shown in Figure 2-2
and secure it to the chassis with a screw.
6. Remove the cap on the rear of the chassis by pushing it
from the inside with your fi nger. (
r
)
7. Pass the 6-pin connector of the cable (E37-1113-15)
through the chassis hole (
t
) and insert the bush into
the chassis hole.
8. Rotate the bush of the cable 90 degrees counterclock-
wise as viewed from the rear of the chassis. (
y
)
9. Insert the 6-pin connector of the cable into the connector
(CN2) of the KAP-2 relay unit. (
u
)
Note: You must setup using the KPG-111D.
INSTALLATION
CN705
:
CN705
CN3
E37-1114-05
@
.
;
CN2
>
=
E37-1113-15
B
Fig. 2-1 Fig. 2-2 Fig. 2-3
FIg. 2-4