18
selected ID in all
fl
eets (Supervisor call).
STATUS MESSAGE
You can send and receive 2-digit Status messages which may
be decided in your talk group. Messages can contain up to 16
alphanumeric characters. Status messages range from 10 to 99
(80 ~ 99 are reserved for special messages).
A maximum of 15 received messages (combined status
messages and short messages) can be stored in the stack
memory of your transceiver.
■
Transmitting
1
Select your desired zone and channel.
2
Press the key programmed as
[Status]
to enter Status
mode (proceed to step 5) or
[S Status]
to enter
Selcall mode (proceed to step 3).
3
Press /
to select the station you want to call.
• If Manual Dialing is enabled, you can enter a station ID
by using the Keypad, or by using
/
When using
/
, cycle through the digits to select a digit, then
press
to set the digit and move the cursor to the right.
Repeat this process until the entire ID is entered.
4
Press to enter Status mode.
5
Press /
to select the status you want to transmit.
• If Manual Dialing is enabled, you can enter a status ID by
using the Keypad, or by using
/
(refer to step 3,
above).
6
Press
the
PTT
switch or
Side 2
key to initiate the call.
• “<COMPLETE>” appears on the display when the status
has been successfully transmitted.
