6
|
KTC-V301E
Installing the Antenna
■
Installation Procedure
Ceramic line
Cable connector
Viewed from inside the vehicle
Slit
Film antenna
(Accessory
1
)
Release paper
1
Film antenna
Slit
Slit
1.
Confirm the installation place.
• Affix the film antennas and cable
connectors to the front windshield
following the laws and regulations of
your country.
• Affix each film antenna so that it does
not overlap the ceramic line. Affixing
the antenna on the ceramic line will
lose the adhesion force.
2.
Using the cleaner (Accessory
0
), wipe dirt off the antenna
installation surface.
3.
Affix each film antenna.
1)
Peel off the release paper (half-
transparent sheet)
1
starting at the
slit, and then affix the film antenna to
the windshield.
• Once peeled off, the remaining
portions of the antenna cannot be
affixed again. Confirm the installation
place again.
2)
Peel off the release paper
2
starting
at either slit, and affix the film antenna
to the windshield.
3)
Peel off the release paper
3
and
release paper
4
and affix the film
antenna to the windshield in the
same manner as above.
• Either the left or right side of the film
antenna can be affixed first.
• Inserting the release paper
1
under
the corner of the film antenna as
shown on the right allows you to peel
off other sheets of release paper easily.
B64-4243-00̲KTC-V301E.indb 6
B64-4243-00̲KTC-V301E.indb 6
08.7.29 10:30:51 AM
08.7.29 10:30:51 AM
