English
29
Specifications
DAB tuner section
Frequency range (L Band) ........................................1452.960 MHz – 1490.624 MHz
Frequency range
(Band III) ..........................................174.928 MHz – 239.200 MHz
Usable sensitivity (L Band) ....................................................- 10 dBm – - 97.5 dBm
Usable sensitivity
(Band III) ........................................................ 0 dBm – - 100 dBm
Mode ................................................................................................Mode I, II, III, IV
General
Operating voltage ..........................................................14.4 V (11 – 16 V allowable)
Current consumption ....................................................................................450 mA
Installation size (W
×
H
×
D) ........................................................143
×
45
×
105 mm
Weight:..............................................................................................................537 g
Specifications subject to change without notice.
What might appear to be a malfunction in your unit may just be the result of
slight misoperation or miswiring. Before calling service, first check the following
table for possible problems.
SOLUTION
POSSIBLE CAUSE
PROBLEM
The DAB antenna is not connected.
Connect it properly by referring to
"Connecting Cables to Terminals".
The PROTOCOL selection switch of the
changer switching unit "KCA-S210A" is
not set properly.
Set the PROTOCOL selection switch to
"N" position.
The frequency is
displayed, but no sound
can be heard.
The unit is outside the reception area.
Try receiving after you have entered the
receiving area.
Nothing happens when
the buttons are pressed.
The computer chip in the unit is not
functioning normally.
Press the reset button on the Control
unit .
The DAB mode cannot
be selected.
The DAB connection cable is not
connected.
Use the DAB connection cable to
connect the control unit and the DAB
hideaway tuner.
Troubleshooting Guide
No sound can be heard,
or the volume is low.
The input/output cables or wiring
harness are connected incorrectly.
Reconnect the input/output cables
and/or the wiring harness correctly. See
the section on "Connecting Cables to
Terminals".
No switching to the
Secondary with
B
and
F
group.
The language is set under the Language
Filter Select Mode function.
Set the Language Filter to off or select
another language.
