104
T
roubleshooting
Receiver/Tuner
I want to clear all the items in PowerTouch and make it to the fac-
tory-set default condition.
•
While holding the
CONFIRM
and
VOLUME DOWN
buttons together,
press and release the
RESET
button under the battery cover . Do not
release the
CONFIRM
and
VOLUME DOWN
buttons until a short
beep indicating the completion of setting is heard.
After the above, all settings are reset to the factory settings.
Receiver/Tuner
My receiver won’t turn on and the STANDBY indicator is flashing.
Your receiver is in the “protection” mode.
Check that:
•
The speaker system’s impedance is not too low. See Chapter One of
the
Connections and Setup Guide
.
•
The speaker wires are not short-circuited. Test the wires as follows to
find the shorted wire and replace it:
1
Turn off the receiver, disconnect the positive and negative speaker
wires of the RIGHT FRONT speaker from the receiver, and turn
the receiver back on.
2
If the STANDBY indicator stops flashing, replace this wire.
3
If the STANDBY indicator does not stop flashing, turn off the re-
ceiver, reconnect the speaker wires, and repeat the first step for the
next speaker.
4
Continue until you have isolated and replaced the shortedwire.
5
See Chapter One of the
Connections and Setup Guide
.
If none of the above solutions work, reset the microprocessor:
1. Turn the receiver off. (The Power button is OFF position.)
2. Press ON/STANDBY button while pressing and holding the Power
button.
The following settings are cleared:
• The device set as input (Tuner is selected by default)—see “How
Do I Operate Devices?” on page 35 of this manual.
• The volume setting (-48dB is selected by default)—see “Adjusting
the Volume” on page 11 of this manual.
