Kenwood KRC-37, Инструкция по эксплуатации

Страница: 27 / 124

— 27 — — 27 —
■
Removing the hard rubber frame
2
When the lower level is removed, remove the upper two
locations.
The frame can be removed from the top side in the same manner.
Catch
Lock
1
Engage the catch pins on the removal tool and remove the two
locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
Accessory
2
Removal tool
Accessory 2 Removal tool
■
Removing the Unit
4
Lower the removal tool
toward the bottom, and pull
out the unit halfway while
pressing towards the inside.
5
Pull the unit all the way out
with your hands, being
careful not to drop it.
Be careful to avoid injury from the catch pins on the removal tool.
1
Refer to the section "Removing the hard rubber frame" and
then remove the hard rubber frame.
2
Remove the screw (M4 × 8) on the back panel.
3
Insert the two removal tools deeply into the slots on each side,
as shown.
Screw (M4X8)
(commercially
available)
KRC-394(E2)_U.S r1 02.11.26 9:32 AM Page 27