OPERATING INSTRUCTIONS
3.
Recording
level should be adjusted
with the volume control
of your
tape recorder.
4.
Recording is not affected by the VOLUME, BASS, TREBLE, BALANCE
and LOUDNESS controls
of the receiver.
2.
Push in the TAPE MON button
(
"
in"
position).
3.
For playback of discrete
4 channel tapes, the MODE switch
should
be set to
DISCRETE position
(
"
DISCRETE"
indicator
lights
up).
For conventional
2 channel tape playback,
set the MODE to 2 CH.
If you wish to get 4 channel
sound from
conventional
2 channel
stereo sources
,
set the MODE switch to RM position.
Set the MODE
switch to SQ for SQ encoded tape playbacks
and to RM for regular
matrix
encoded tape reproductions
.
Reproduction
of CD-4 discs
is possible
with this
receiver
in con
·
junction
with
the
KCD-2
(optional
equipment)
which
can
be easily
plugged into the receiver's
rear panel.
The plug-in connector
is located
under a covering
lid at the lower left corner of the receiver's
rear which
can be taken off by removing
two screws.
Position the KCD
-
2 with the
arrowhead
mark
on the
front
panel
pointing
up
when
making
the
plug·in
connection
.
Remember
that the
player
must
have a suitable
CD-4 cartridge,
and
it is recommended
that
low capacity
connecting
cables be used between it and the receiver
.
1.
Set the SPEAKERS buttons
as desired.
Release the TAPE MON
switch to extended "out"
position.
2.
Set the SELECTOR switch of the KR-6340 to CD-4 position
("CD-4"
indicator
lights
up however
,
this
indicator
will
not
light
unless
KCD-2 is inserted).
3.
Set the
MODE switch
to
DISCRETE position.
("DISCRETE"
in
·
dicator
lights up)
.
4.
Play the test
record
supplied
with
the
KCD-2 in accordance
with
the
directions
outlined
in
the
KCD-2
Operating
Manual.
The
"
RADAR"
indicator
will
light up when the test record
is played to
show that CD-4 discrete
disc reproduction
is in progress
.
AMP CONTROL SWITCH SET TO 2CH
Switching
the AMP CONTROL switch to the 2CH side lines up the
two amplifiers
on the left side to work as one
,
and the two amplifiers
on the
right
side also to work as one.
This more than
doubles
the
stereo two-channel
power output.
(15 watts per channel into 8 ohms at
20 -
20,000
Hz in 4-channel
mode
;
40 watts per channel
in 2-channel
mode).
This is indicated
by the illumination
of the 2CH indicator
on
the front
panel.
When the amplifiers
are worked
in this
manner,
the
MODE switch should
.
be set to either 2CH or MONO as desired.
NOTE:
Always leave the power switch off when resetting
the AMP CONTROL
switch.
Otherwise
it will
activate
the protection
circuit
to momen
·
tarily
cut off sound
.
This does not indicate
damage,
however.
brought to you by www.stephsrecordsale.com
