Kenwood KDC-W7041U, Инструкция по эксплуатации

Страница: 16 / 32

16
|
KDC-W7541U/KDC-W7541UY/KDC-W7041U/KDC-W7141UY
Other Functions
Now, you can use the unit.
⁄
• If an incorrect code is entered, “Waiting” is displayed, and
the input prohibition periods shown in the table below
is generated.
After the input prohibition time lapses, “SECURITY” is
displayed, and you can reenter the code.
Number of times the
incorrect code was input Input prohibited time
1 —
2 5 minutes
3 1 hour
4 24 hours
Security Code
When Security Code is set, possibility of theft
is reduced because input of Security Code is
prompted to turn on the unit once it is turned off.
⁄
• When you activate the Security Code function, it cannot be
released.
Note, your Security Code is the 4 digit number entered in
your “Car Audio Passport” in this package.
1
Select Security Code item during Menu
mode (In Standby mode)
“Security Set” is displayed.
For how to select Function Control items, refer to
<Function Control> (page 6).
2
Enter Security Code mode
Press the Control knob for at least 1 second.
When “Enter” is displayed, “SECURITY SET” is also
displayed.
3
Enter Security Code
Operation type Operation
Select the digits to enter Push the Control knob towards right
or left.
Select the Security Code
numbers Turn the Control knob or push it
towards up or down.
4
Confirm the Security Code
Press the Control knob for at least 3 seconds.
When “Re-Enter” is displayed, “SECURITY SET” is also
displayed.
5
Do the step 3 through 4 operation, and reenter
the Security Code.
“Approved” is displayed.
The Security Code function activates.
⁄
• If you enter a Code different from your Security Code,
you have to start over from step 3.
6
Exit Security Code mode
Press the [FNC] button.
Entering Security Code
The Security Code is required to use the audio unit
when the unit is first used after removed from the
battery power source or the Reset button is pressed.
1
Turn the power ON.
2
Do the step 3 through 4 operation, and reenter
the security code.
“Approved” is displayed.
Manual Clock Adjustment
1
Select Clock Adjustment item during Menu
mode (In Standby mode)
Select the “Clock Adjust” display.
For how to select Function Control items, refer to
<Function Control> (page 6).
2
Enter Clock adjustment mode
Press the Control knob for at least 1 second.
The clock display blinks.
3
Adjusting Clock
Operation type Operation
Selecting the item (hours or
minutes) Push the Control knob towards right
or left.
Adjust each item Turn the Control knob or push it
towards up or down.
4
Exit Clock adjustment mode
Press the [FNC] button.
⁄
• You can do this adjustment when “MENU” > “SYNC” in
<Function Control> (page 6) is set to “OFF”.
B64-4049-00̲00̲E̲English.indd 16 B64-4049-00̲00̲E̲English.indd 16 08.2.5 4:25:05 PM 08.2.5 4:25:05 PM