Kenwood KAC-PS810D, Инструкция по эксплуатации

Страница: 7 / 32

English
7
Connection
REVERSE NORMAL
PHASE BAND REJECT
–12dB
–6dB
OFF
B.M.S.
+12dB
OFF
REMOTE
INFRASONIC
25Hz 15Hz ON OFF
GND
LINE OUT EXT.AMP.CONT. LINE IN
L
R
L
R
25 25 25
SPEAKER
OUTPUT
POWER IN
P.CON BATT.
GND
FUSE(25Ax3)
^ ( & *
! @ # $ %
!
Fuse (25 A
×
3)
@ Battery terminal
# Ground terminal
%
Speaker output terminals
As this unit accepts speakers with a
minimum impedance of 1 ohm, connect
speakers with 1-ohm or higher impedance
to these terminals.
The rated input of the speakers should be
no less than the maximum output of the
amplifier. Otherwise malfunction may
result.
^
RCA cable ground lead terminal
When using an RCA cable with a ground
lead attached, connect the ground lead to
this terminal.
&
LINE IN terminal
*
LINE OUT terminal
The signal that’s input from the line input
terminal is output.
$
Power control terminal
Controls the unit ON/OFF.
Controls the unit power. Be sure to connect it
with all the systems.
(
EXT.AMP.CONT. (external
amplifier control) terminal
Controls the B.M.S. Only Kenwood center
unit models sold in 1999 or later with a
"EXT.CONT."/"EXT.AMP.CONT." wire
attached can be used.
Also, a maximum of 3 power amplifiers can
be operated at the same time.
There are cases when operation may not be
possible due to wiring wire type and length.
NOTE
NOTE
2
CAUTION
■
Terminal names