Kenwood JE700, Руководство пользователя

Страница: 6 / 58

assembly and use
1 Fit the pulp collector ensuring the spout and anti-
drip control are to the front of the juicer.
2 Fit the filter inside the pulp collector .
3 Put the lid on. Then turn the lid to the back of the juicer
until it locks . Your juicer will not work if the lid
is unlocked.
4 Place the hopper onto the lid . Note: The hopper can
be inverted for storage on the juicer
.
5 Push any excess cord into the compartment at the back
of the juicer.
6 Put the juice jug under the outlet. The froth separator
in the jug ensures that the juice is free from froth.
7 Cut the food into small pieces to fit the feed tube.
8 Press the anti-drip control up during juicing. After use, to
prevent the juice dripping, press the anti-drip control
down.
9 Push the lever down to switch on and the light will
come on. Then push the food down using the pusher.
● Some very hard foods may make your juicer slow down
or stop. If this happens switch off and unblock the filter.
●
Switch off and clear the pulp collector regularly during
use.
Reverse the assembly procedure to take the juicer apart.
Always unplug after use.
hints
● Insert soft food slowly to get the most juice.
●
Vitamins disappear - the sooner you drink your juice,
the more vitamins you'll get.
●
If you need to store the juice for a few hours put it in
the fridge. It will keep better if you add a few drops of
lemon juice.
●
Don't drink more than three 230mls (8 fl.oz.) glasses of
juice a day unless you're used to it.
●
Dilute juice for children with an equal amount of water.
●
Juice from dark green (broccoli, spinach etc) or dark
red (beetroot, red cabbage etc) vegetables is extremely
strong, so always dilute it.
● Fruit juice is high in Fructose (fruit sugar), so people
with diabetes or low blood sugar should avoid drinking
too much.
● Don't mix fruit and vegetable juice together (apart from
apple and carrot) - it can cause painful wind or
bloating.
to use your citrus juicer
1 Fit the pulp collector . To prevent leaking the pulp
collector must be fitted. Press the anti-drip control up
during juicing. After use, to prevent the juice dripping,
press the anti-drip control down.
2 Put the strainer inside the pulp collector - turn until it
locks , then add the cone .
3 Put the juice jug under the outlet.
4 Push the lever
down to switch on and the light will
come on. Cut the fruit in half. Then press each half
down on to the cone and the juicer will operate
automatically.
● To help with juice extraction move the fruit from side to
side.
5 To stop the juicer lift the fruit from the cone.
● When juicing large quantities, empty the strainer
regularly to prevent the build up of pulp and seeds.
Empty the juice jug as required.
important
●
Don’t press too hard on the cone or run
continuously for longer than 10 minutes - you
may damage your juicer.
cleaning
●
Always switch off, unplug and dismantle before
cleaning.
●
If the filter is too tight to remove, wait a few minutes
until it loosens up.
● Do not wash any of the parts in the dishwasher.
● Some foods, eg carrot, will discolour the plastic.
Rubbing with a cloth dipped in vegetable oil helps
remove discolouring.
motor unit
● Wipe with a damp cloth, then dry.
pulp collector
● Wash in hot soapy water.
filter
● Clean using a soft brush.
●
Check the filter regularly for signs of
damage. Do not use if the filter is damaged.
Refer to “service and customer care”
other parts
●
Wash in hot soapy water.
Note: The hopper can be inverted for storage on the juicer
.
3