Kenwood DPX502U, Инструкция по эксплуатации

Страница: 31 / 44

English
|
31
In Standby mode
Firmware version display
Displaying the firmware version with the unit.
1
Select the firmware version display mode
Push the Control knob towards up or down.
Select the "F/W VER" display.
2
Display the firmware version
Push the Control knob towards right or left.
In Standby mode
Demonstration mode Setting
Sets the demonstration mode.
1
Select the Demonstration mode
Push the Control knob towards up or down.
Select the "DEMO" display.
2
Set the Demonstration mode
Press the Control knob for at least 2 seconds.
Each time you press the knob at least 2 seconds,
the Demonstration mode alternates between the
settings shown in the table below.
Display Setting
"DEMO ON" The Demonstration mode function is ON.
"DEMO OFF" Exit Demonstration mode (Normal mode).
Other than Standby mode
Audio Preset Recall
Recalling the sound setup registered by <Audio
Preset Memory> (page 30).
1
Select the source
Press the [SRC] button.
2
Enter Menu mode
Press the [MENU] button for at least 1 second.
"MENU" is displayed.
3
Select Audio Preset mode
Push the Control knob towards up or down.
Select the "A-PRESET" display.
4
Enter Audio Preset mode
Press the Control knob for at least 1 second.
5
Select the Audio Preset Recall
Push the Control knob towards up or down.
Select the "RECALL" display.
6
Recall the Audio Preset
Press the Control knob for at least 2 seconds.
The "RECALL" display blinks 1 time.
7
Exit Audio Preset mode
Press the [MENU] button.
⁄
• The User memory of <System Q> (page 8) is changed to
the value which was recalled.
• The source tone memory item of <Audio Control> (page
8) is changed to the value which was recalled by the
selected source.
• The following items cannot be registered.
Volume, Balance, Fader, Loudness, Volume offset, Dual
Zone System, Rear Volume
B64-3829-00̲00.Indd 31 B64-3829-00̲00.Indd 31 07.5.8 9:21:59 AM 07.5.8 9:21:59 AM