Kenwood DNX8160DABS, Инструкция по эксплуатации

Страница: 85 / 117

Controlling Audio
84 84
Crossover network setup
You can set a crossover frequency of
speakers.
1
Touch [X’over].
X’over screen appears.
2
Touch the speaker to set.
3
Set each item as follows.
HPF FREQ
High Pass Filter adjustment. (When front or rear
speaker is selected on Speaker Select screen)
LPF FREQ
Low Pass Filter adjustment. (When subwoofer
is selected on Speaker Select screen)
Slope*
3
Sets a crossover slope.
Gain
Adjusts the front speaker, rear speaker, or
subwoofer level.
TW (Tweeter) Gain *
1
Adjusts the tweeter level. (When front is
selected on Speaker Select screen)
Phase Inversion*
2
Sets the phase of subwoofer output.
Check [Phase Inversion] to shift the phase
180 degrees. (When subwoofer is selected on
Speaker Select screen)
* 1 Only when “Tweeter” is set to “Small”,
“Middle”, “Large” in <Speaker Setup>.
*
2
Only when “Subwoofer” is set to a mode
other than “None” in <Speaker Setup>.
*
3
Only when “LPF FREQ”/“HPF FREQ” is set to
a mode other than “Through” in <X’over>.
When Speaker network is set to 3 way:
(DNX8160S only)
FREQ (High Pass)
High Pass Filter adjustment. (When tweeter is
selected on Speaker Select screen)
HPF FREQ, LPF FREQ (Band Pass)
Band Pass Filter adjustment. (When mid range
speaker is selected on Speaker Select screen)
FREQ (Low Pass)
Low Pass Filter adjustment. (When woofer is
selected on Speaker Select screen)
Slope*
3
Sets a crossover slope.
Gain
Sets gain of each speaker.
Phase Inversion*
2
Sets the phase of tweeter, mid range, and
woofer output.
Check [Phase Inversion] to shift the phase 180
degrees.
NOTE
• For how to switch to the 3-way speaker system,
see
3 way speaker system setup (P.85)
.
Connecting 3-way speakers with the 2-way mode
selected can break the speakers.