Kenwood CR-ST100S, Руководство по эксплуатации

Страница: 53 / 160

21
14.6 Save:
Once you have made all the settings, please press the <OK> button to save the settings.
An activated alarm clock is shown with an alarm symbol and the number of the active alarm clock at
the bottom left of the display. In standby mode you can also see the set alarm time.
14.7 Switching off the alarm clock after waking up
To switch off the alarm clock until the next alarm cycle, please press the <Standby> button on the
device or on the remote control “Alarm off” appears briefly on the display. If you only want to inter -
rupt the alarm function for a few minutes (snooze), you can use any other button. The alarm delay
is set by pressing a button in steps
5, 10, 15 and 30 minutes and can also be extended again and
again. After a short time, the radio automatically switches back to “Standby” and the time remai-
ning until waking up again is displayed next to the flashing alarm symbol.
Note: The saved wake-up times are retained in the event of a power failure.
15. System settings
In the system settings you can change the settings of the radio and call up important information
about it.
15.1 Equalizer
With the equalizer you can adjust the sound of the radio to your liking. You can choose from precon-
figured settings or create your own profile. Please proceed as follows:
Press the <MENU> , button and select "System Settings" and then "Equalizer” . You can select
a sound profile with the <UP> or <DOWN> buttons and then confirm with <OK> . The following
profiles are available:
Normal / Flat / Jazz / Rock / Movie / Classic / Pop / News / My EQ
Setting up “My EQ” :
To do this, please navigate to "My EQ profile setup" and confirm with <OK> . The “Bass” and "Tre-
ble" can now be set in the following menu. Confirm the "Bass" or "Treble" with the <OK> button,
make the appropriate settings with the <LEFT> or <RIGHT> buttons and confirm with the <OK>
button. Alternatively, these settings can also be made with the <NAVIGATE> knob. The active sound
profile is marked with "*" .