3
Switching On
W
hen the
PRO KADI
is switched on, the words
KENTON
PRO KADI
scroll across the display.
The Display
There are 3 digits on the 7-segment display. The 1st digit shows which parameter is ready for editing.
The right-hand, 2nd & 3rd digits will then display what the value of the parameter is.
There are also 2 red dots which you may see appear. The 1st dot when lit indicates the
SELECT
button is in reverse operation (see below), the right dot when MIDI, information is being received on
the selected channel. The dot on the far right is not utilised by this unit.
Stepping through parameters
Each parameter is accessed using the
SELECT
button. There are 14 parameters in the menu, listed in
the next section `Parameters`.
Press the
SELECT
button to get to the parameter in question, then use the
INC
rement (+) and
DEC
rement (-) buttons to edit the value.
If you press and hold the
SELECT
button for more than 1 second, you can step through the
parameters in the opposite direction. A red LED dot will light up to indicate this. If the
SELECT
button
is pressed and held for 1 second again, the direction will return to normal and the red LED dot will
disappear.
Displaying values above 99
When displaying values from 0 to 99, you will see the digits as you would expect.
When displaying values above 99, the following format is used :-
a dash " - " at the bottom of the left-hand display = 100+
a dash " - " in the middle of the left-hand display = 110+
a dash " - " at the top of the left-hand display = 120+
No values above 129 are used.
Speeding up editing
If you press and hold the
INC
key, then also hold the
DEC
key, the value will increase faster. If you
press and hold the
DEC
key then also hold the
INC
key, the value will decrease faster.
Storing Set-ups
The set-ups can be stored in non-volatile memory. To do this, press & hold the
SELECT
button (for
approx. 6 seconds) till the display reads `st`(store).
EDITING THE
PRO KADI
Not Used
SELECT steps
backwards
MIDI
info
.
