8
7
iii. Settings Tab
Setting tab allows to set the Date, Time and customize
display brightness as per requirement.
a. Clock Setup
b. Date Setup
c. Brightness Setup
a. Clock Setup
To set time, click on the Clock setup once. A window will
pop up as shown in the figure.
Use the arrows to set the correct time.
To save the time settings, press
'Save'
button on the
interface once.
Time saved message will pop up for 5 Sec., confirming
that the settings has been saved.
n
n
n
Note:
To go back to the settings menu click the return arrow or cancel button
b. Date Setup
To set date, click on the
'Date Setup'
menu once. A window
will pop up as shown in the figure.
Use the arrows to move to the correct date.
To save the date settings, press
'Save'
button on the
interface once.
Date saved message will pop up for 5 Sec., confirming
that the settings has been saved.
n
n
n
c. Brightness Setup
Touch the
'Brightness Setup'
button to set brightness level.
Brightness levels can be set in a range of 0 to 26.
Brightness levels can be increased or decreased by
pressing left and right arrow as shown below.
After achieving the correct brightness level, touch the
'Save'
button to save the brightness level.
To cancel brightness setting, touch the cancel button. The
screen will run with previously set brightness levels.
n
n
n
n
To ensure delivery of purer and healthier water, a micro-processor is installed in the purifier that performs the
following functions:-
UV Stabilization Delay:
To ensure that the UV lamp is pre-heated and is working at its optimum level before it
starts disinfecting water, the controller provides a two seconds delay to UV lamp when the purifier is switched on.
During this period, only the UV lamp is switched on and other electrical devices of the purifier are switched off.
Purification Delay:
To ensure that the idle water lying in the internal pipes and in the UV chamber is disinfected
before being passed into the storage tank, the system provides a 5 seconds delay when the purifier is switched on.
During this time, the UV lamp kills all micro-organisms that may be in the water inside UV chamber. After this delay,
all other electrical devices such as booster pump and solenoid valve are switched on to start normal
purification process.
Alarm:
To ensure delivery of purer water, KENT Superb in-built micro controller controls and senses various vital
components and displays their status on the digital interface.
Computer Controlled Operation
UV lamp Failure
KENT Superb Mineral RO™ Water Purifier is equipped
with a safety feature, which displays a warning signal when
and if the UV lamps fails or stops working. The purifier
would stop purifying water till the UV lamp is not replaced.
If the interface shows UV failure message, switch off the
purifier and call the service technician for help.
Filter Replacement
The in-built smart system will display a message, warning
the user to replace filter when less than 60 hours of filter life
is left.
On completion of filter life, 'Replace filter Message' will be
displayed on the screen, and the purifier would stop
purifying water till the filter is not replaced.
If the interface shows 'Replace Filter Message', switch off
the purifier and call the service technician for help.
