3
4
Speed
Kent Eternal Air Purifier comes with three different speed settings.
These different speed settings-low, medium & high allow you to
select a particular speed that suit the need.
To vary speed, press speed button on control panel
• For Low speed - press button once
• For Medium speed - press button twice
• For High speed - press button thrice
Timer
Kent Eternal Air-Purifier comes with three different timer settings. These different
settings - 1 hour, 4 hours & 8 hours, allow you to select a usage as per your needs.
To set timer, press the ‘TIMER’ button on control panel
• To Set timer for 1 hour - press button once
• To Set timer for 4 hours - press button twice
• To Set timer for 8 hours - press button thrice
When the set time is up, the purifier will stop and turn off.
Using KENT Eternal Air Purifier
Mode Selection
1. Unpack the unit completely and remove any stickers that can prevent unit operation.
2. Install filters in the correct format.
3. Check the unit for damages, do not use it in case of any damages.
4. Before switching the unit on, make sure that your home mains voltage corresponds to the
unit operating voltage.
5. Once connected to the main power supply, the appliance will make a three-tone sound
indicating that it is ready for use.
6. To start the KENT Eternal Air Purifier, press ON/OFF button. The appliance will give a
harmonious ringtone to indicate that it is on. In 3 seconds that appliance would start with
in Auto-Mode.
7. To turn off the machine, press ON/OFF button.
Mode 1 - Auto
In this mode the Air Purifier automatically adjusts the settings (Speed - low, medium, high)
based on the air quality sensed by order sensor. The current air quality is displayed by Air
Quality indicator using different colours (blue, light blue, pink and red).
In Auto Mode, the appliance can differentiate between day and night and adjust itself
accordingly. At night with lights turned off the purifier would enter into SLEEP MODE after 30
seconds. All the indicators on display and operations screen will turn off and the purifier will
run silently allowing for a peaceful night.
In morning the purifier would come out of the sleep mode and resume its normal operations
with settings depending upon the air quality.
To run the purifier in this mode, press ON button once.
Mode 2 - Silent
• In this mode the Air Purifier runs with less noise
• To run the purifier in this mode press MODE button on control
panel once
Mode 3 - Turbo
• Is recommended to run the purifier in TURBO mode if the
room is heavily polluted or has high smoke/soot content
• To run the purifier in this mode press MODE button on control
panel twice
For your convenience, the Air Purifier comes with three different modes. These different
modes allow you to select a particular settings as per the needs.
3. Remove Activated Carbon Filter, as shown in the figure.
2. Remove Antibacterial HEPA Filter, as shown in the figure,
by pulling the handle attached to the filters.
4. Remove plastic packaging on the filters and reinstall in the
reverse order.
5. To put the back cover in the air purifier, Insert the snaps at the
bottom of back cover into slots, and push the upper part in.
6. Always install the filters in correct position, by following the
markings on the top of the filters.
Note:
The purifier will reboot after power cut.
TURBO
