INSTRUCTIONS FOR USE
ENGLISH
Razor E17
909 6311 000(3)2009-11
13
AFTER USING THE MACHINE
After working, before leaving the machine:
Remove the brush/pad-holder as follows:
1.
With the brush/pad-holder lifted, turn the brush/pad-holder switch (52) to “I” and, after a few seconds, back to “0”, thus
•
releasing the brush/pad-holder.
Disconnect the power supply cable (21) from the electrical mains and place it on the holder.
2.
Empty the tanks (26 and 27) as shown in the previous paragraph.
3.
Perform the daily maintenance procedures (see the Maintenance chapter).
4.
Store the machine in a clean and dry place, with the brush/pad-holder and the squeegee lifted or removed.
5.
RECOVERY TANK REMOVAL
To perform check and maintenance procedures, it may be necessary to remove the recovery tank (26) as shown below.
Empty the recovery tank (26) as shown in the relevant paragraph.
1.
Drive the machine on a level loor.
2.
Make sure that the power supply cable (21) is disconnected from the electrical mains.
3.
Disconnect the vacuum hose (22) from the squeegee (11).
4.
Disconnect the recovery water drain hose (16) from the bracket (17).
5.
Open the cover (6).
6.
Grasp the recovery tank (A, Fig. 5) in the area (B) and slightly raise it.
7.
Disconnect the vacuum hose (C) from the tank, then remove the tank (A) with the hoses (D) and (E).
8.
A
C
B
D
E
Figure 5
S310243A
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
Perform the procedures shown in After Using the Machine paragraph.
1.
Store the machine in a clean and dry place.
2.
FIRST PERIOD OF USE
After the irst 8 hours, check the machine fastening and connecting parts for proper tightening. Check the visible parts for integrity
and leakage.
https://harrissupplyind.com - To Order Parts Call 608-268-8080
