6
6
6
6
6 - FORM NO. 56041536 - SelectGloss
™
21PH, 21PK, 27PK, 27PO, 27PR
MACHINE OPERA
MACHINE OPERA
MACHINE OPERA
MACHINE OPERA
MACHINE OPERATION
TION
TION
TION
TION
FOR SAFETY: Do Not operate machine unless Operation Manual is read
and understood.
ST
ST
ST
ST
STARTING MACHINE
ARTING MACHINE
ARTING MACHINE
ARTING MACHINE
ARTING MACHINE
1
With machine on level surface. check oil level prior to starting
machine.
2
Tilt machine back onto rear caster (Park Position).
3
Remove any packing materials and obstructions from drive
system.
4
Turn LPG fuel knob ON tank. Check LPG gas level meter.
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: Opening service valve too quickly may cause service check valve
to stop flow of LPG fuel. If check valve stops fuel flow, close service
valve, wait a few seconds and open valve slowly again.
5
Push throttle lever to choke position for Honda engine only. All
other engines start in IDLE position.
6
Press start button OR turn key (if required) to engage starter. Do
not engage starter button for more than 20 seconds at a time. If
starter overheats it trips an internaI overload switch and will not
crank over. Wait at least 20 to 30 seconds between tries. When
engine starts, ease throttle back to running position. Do not hold
starter button in a continuous ON position, starter will burn out.
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: For Electric Clutch model, see “OPERATING ELECTRIC CLUTCH”.
CAUTION!
CAUTION!
CAUTION!
CAUTION!
CAUTION!
Be careful not to allow the machine to come in contact with loose tiles
or other loose materials, remember the pad driver Is moving at very high
speed, and Injury can occur to the operator or passers by If pad driver
flings the loose material.
OPERA
OPERA
OPERA
OPERA
OPERATING ELECTRIC CLUTCH (OP-
TING ELECTRIC CLUTCH (OP-
TING ELECTRIC CLUTCH (OP-
TING ELECTRIC CLUTCH (OP-
TING ELECTRIC CLUTCH (OP-
TIONAL)
TIONAL)
TIONAL)
TIONAL)
TIONAL)
1
Once engine starts, move throttle control to SLOW rpm.
2
With throttle in SLOW, engage clutch by squeezing trigger
switch.
3
After clutch is engaged, move throttle to 3/4 throttle position and
then lower pad driver to floor.
CAUTION!
CAUTION!
CAUTION!
CAUTION!
CAUTION!
Never engage clutch In fast run position or with pad driver
on floor, this will cause damage to clutch.
STOPPING MACHINE
STOPPING MACHINE
STOPPING MACHINE
STOPPING MACHINE
STOPPING MACHINE
1
Turn LPG valve OFF at tank while running. This serves to purge
or bleed fuel hoses and carburetor system of fuel, so that there
is no danger of gas escaping from lines when tank is removed for
outside storage.
2
Tilt machine back on rear caster .
3
Engine will stop running when fuel lines bleed clear.
4
Pull throttle lever to STOP position after engine has stopped.
5
Turn key off if equipped.
EMERGENCY STOPPING
EMERGENCY STOPPING
EMERGENCY STOPPING
EMERGENCY STOPPING
EMERGENCY STOPPING
1
Pull throttle back to STOP OR turn off key if equipped.
2
Turn LPG valve OFF at tank.
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: Engine may back fire when stopped in this manner.
If machine is equipped with Kill Switch Option, activate switch.
WHILE OPERA
WHILE OPERA
WHILE OPERA
WHILE OPERA
WHILE OPERATING MACHINE
TING MACHINE
TING MACHINE
TING MACHINE
TING MACHINE
W
W
W
W
WARNING!
ARNING!
ARNING!
ARNING!
ARNING!
Exhaust contains poisonous carbon monoxide gas. Avoid
Inhalation of exhaust gases. Never operate machine in a
confined area without proper ventilation.
1
Refer to (SAFETY PRECAUTION: WHEN OPERATING MACHINE)
on page 4.
2
Do not run machine for more than 15 seconds in one spot or
damage will occur to the floor.
3
Do not leave unattended in idle position or with engine running
period. If machine needs to be idled for short periods, tilt
machine back and move throttle to idle. Machine should now
idle safely.
A
A
A
A
ATTENTION!
TTENTION!
TTENTION!
TTENTION!
TTENTION!
Do not Idle more than 5 minutes, longer periods will affect
oil flow and will cause damage to the engine.
4
For easier maneuverability, always start on right side of aisle.
Содержание SelectGloss 21PH
Страница 32: ......
