S-MIX-PRO1600
21
7.Communication protocol and control
instruction code
Communication protocol: (baud rate 115200, data bit 8, stop bit 1, check digit none)
Remark
：
1.In the above table, a represents input and b represents output. The subscripts “1”, “2”, and “3” in the
instruction are not transmitted characters. The range of values of a and b depends on the controlled
matrix. As a command input error handling;
2.Punctuation marks are all punctuation marks in the English input method;
3.All commands end with ".", the first letter of the word can be capitalized.
Some instruction code examples
1. Switch the 1st input signal to the 2nd port output and send the command: 1X2.take.
Type
Control command
Function description
Op
e
ra
tio
n
c
o
m
m
a
n
d
s
aXb.take.
Switch the input of a road to the output of b road
aX1-b.take.
Switch the input of a road to the output of 1-b road
aXb1,b2,b3.take.
Switch the input of a way to the output of b1, b2, b3
a1Xb1.a2Xb2.a3Xb3.take.
Switch the a1, a2, and a3 inputs to the corresponding b1, b2,
and b3 outputs.
NXN.Take.
Special switch (one-to-one switching of all input and output)
）
Save[Y].
Save the current status to the [Y] memory location, [Y] is the
1-12 number key
Recall[Y].
Invokes the input/output switching status of the [Y] memory
location. [Y] is a 1-12 number key
Buzzer on.
Turn on the buzzer
Buzzer off.
Turn off the buzzer
Backup On.
Turn on video backup
Backup off.
Turn off video backup
Reset.
reset
Get table.
Get switching status table
1U1.TAKE.
USB switch
savep[Y].
Splicing save command
recallp[Y].
Splicing recall command
