20
Service Prevention Checklist, continued
OCCURRENCE
POSSIBLE CAUSE
SOLUTION
WATER
Water collects in folds of
the bellows at the end of
the cycle.
This is a result of the washing action and is
part of the normal operation of the washer.
Water collects in bleach and
fabric softener compart-
ments.
This is a result of the siphoning action and is
part of the normal operation of the washer.
Water may be removed by removing the dispenser drawer
(see Care and Cleaning in this guide) and draining water
into the empty drum or sink.
Wash load too wet after
spin.
Washer is overloaded.
Do not overload washer. See Operating Your Washer, step
4.
Load is too small.
Add 1 or 2 similar items to help balance the load.
Load is out of balance.
Rearrange load to allow proper spinning.
Drain hose is kinked.
Straighten drain hose.
Water does not enter
washer or it enters slowly.
Water supply is not adequate in area.
Check another faucet in the house. Wait until water supply and
pressure increase.
Water supply faucets are not completely
open.
Fully open hot and cold faucets.
Water is being used elsewhere in the
house. Water pressure must be at least 30
psi (260 kPa).
Avoid running water elsewhere while washer is fi lling.
Water inlet hoses are kinked.
Straighten hoses.
Warm or hot water is not
hot enough.
Hot water heater is set too low or is a
distance from washer.
Measure hot water temperature at nearby faucet with
candy or meat thermometer. Water temperature should
be at least 120°F (49°C). Adjust water heater as necessary.
Hot water is being used elsewhere in the
house.
Avoid using hot water elsewhere before or during washer
use. There may not be enough hot water available for
proper cleaning. If problem persists, your hot water sys-
tem may be unable to support more than 1 use at a time.
Water in washer does not
drain or drains slowly.
Drain hose is kinked or clogged.
Clean and straighten the drain hose.
Drain hose standpipe is too tall. Maximum
standpipe height is 8’ (2.4 m).
Reduce standpipe height to less than 8’ (2.4 m). See
INSTALLATION INSTRUCTIONS.
House drain pipes are clogged.
Unclog drain pipes. Contact plumber if necessary.
Water leaks.
Fill hose connection is loose at faucet or
washer.
Check and tighten hose connections. Install rubber sealing
washers provided.
Oversudsing.
Wrong detergent.
Run rinse cycle. Use a low-sudsing, high effi ciency deter-
gent.
Too much detergent.
Run rinse cycle. Use less detergent in future loads.
Incorrect wash and rinse
temperatures.
Hot and cold water hoses are connected to
wrong supply faucets.
Connect hot water hose to hot water faucet and cold
water hose to cold water faucet.
Water is entering washer
but tub does not fi ll.
Drain hose standpipe is too low. Standpipe
must be a minimum of 23.6” (60 cm) high
to prevent siphoning.
Increase standpipe height to at least 23.6” (60 cm). See
INSTALLATION INSTRUCTIONS.
Содержание C4909
Страница 22: ...22 Notes ...