Kenmore 970-6856 Series, Инструкция по использованию и уходу

Страница: 26 / 32

26
Replacing oven light
Be sure the range is unplugged and all parts
are COOL before replacing oven light. Wear a leather-
faced glove for protection against possible broken glass.
The oven light is located
at the rear of the oven
cavity and is covered
with a glass shield held
by a wire holder. The
glass shield protects the
light bulb and must be in
place whenever the oven
is in use.
wire
holder
glass
shield
To replace interior oven light bulb:
1. Turn electrical power off at the main source or unplug
the range.
2. Press wire holder to one side to release the glass shield
that covers the light bulb.
3. Replace light with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder
back into place.
5. Turn power on at main source (or plug the appliance in).
6. The clock will then need to be reset. To reset, see
Setting clock in this Use & Care Guide.
Care & Cleaning
Please note:
On some models the lower oven bake element is visible.
The following cleaning instruction applies ONLY for models
that have a visible lower bake element.
Cleaning oven bottom (on some models)
Oven elements may appear to have cooled
after they have been turned off. The oven bake and broil
elements may still be hot and burns may occur if touched
before they have cooled sufficiently.
The bake element may be tilted from the front for better
access to the oven bottom for cleaning. It is recommended
to remove spill-overs from the oven bottom before running
a self-clean cycle. Be careful not to raise the element more
than 4 or 5 inches from a resting position.
On models with visible
bake element only;
lower bake element
may be raised from the
front 4-5 inches to
clean oven bottom.