Kenmore 796.8099, Инструкция по использованию и уходу, а также инструкция по установке

Страница: 17 / 124

17
E
n
GLISH
INSTALLATION INSTRUCTIONS
CorrectVenting
Restricted or Blocked Airflow
Avoid long runs or runs with multiple elbows or
bends.
Check for blockages and lint buildup.
Make sure the ductwork is not crushed or
restricted.
Your dryer features FlowSense
™
, an innovative sensing system that automatically detects
blockages and restrictions in dryer ductwork. Keeping ductwork clean of lint buildup and free of
restrictions allows clothes to dry faster and reduces energy use.
NOTE: When the dryer is first installed, this test should be performed to alert you to any existing
problems with the exhaust duct in your home. However, since the test performed during normal
operation provides more accurate information on the condition of the exhaust duct than does the
installation test, the number of bars displayed during the two tests may not be the same.
Toactivatetheflowcheck(Ductconditiontest):
NOTE:Dryer heating test must be performed before proceeding. Then perform the duct condition
test below:
If no bars are shown in the
display, the ductwork is free from
blockages
or restrictions.
If all bars are lit, the dryer
ductwork has a blockage
that needs to be removed
immediately.
IMPORTANT:Do NOT
interrupt the test cycle!
THE DUCTWORK IS FREE
FROM BLOCKAGES OR
RESTRICTIONS.
COMPLETED FLOW CHECK
THE DUCTWORK HAS
A BLOCKAGE THAT NEEDS
TO BE REMOVED
IMMEDIATELY.
NEED FLOW CHECK
1
5
CUSTOM PGM
*PGM SAVE
OPTION
*LANGUAGE
FLOW CHECK
THIS TEST CHECKS THE CONDITION
OF THE EXHAUST DUCT AT THE TIME
OF INSTALLATION
HIGH
0:02
EST. TIME
REMAINING
FLOW CHECK
0:02
EST. TIME
REMAINING
HIGH
After pressing the POWER ON/OFF, turn the cycle
knob.
2
When pressing the OPTION button, OFF will be
displayed.
3
When pressing CUSTOM PGM, OFF will be change to
ON.
ON I
FLOW CHECK
4
After 3 seconds, or by
pressing the EXIT button, the
display will show the FLOW
CHECK start screen.
Press START/PAUSE. The
dryer will run for approximately
2 minutes to test for
blockages or restrictions
to air flow in the
ductwork.
FLOW CHECK (DUCT CONDITION TEST)