Kenmore 795.58812.900, Руководство по обслуживанию

Страница: 17 / 85

- 17 -
REFRIGERATOR COMPARTMENT)............................DEFFECTIVE: “ULTRA ICE” INDICATOR WILL NOT BE LIT
WATER TANK SENSOR...............................................DEFFECTIVE: “LOCK” INDICATOR WILL NOT BE LIT
ICE-MAKER SENSOR..................................................DEFFECTIVE: “CUBE ICE” INDICATOR WILL NOT BE LIT
ICE-MAKER ASSEMBLY...............................................DEFFECTIVE: “CRUSH ICE” INDICATOR WILL NOT BE LIT
AMBIENT SENSOR......................................................DEFFECTIVE: “FREEZER TEMPERATURE LOWER” INDICATOR
WILL NOT BE LIT (SEE FIG. 1)
R2-SENSOR (LOWER SENSOR IN
By pressing and holing freezer temperature adjust button and ultra ice button all leds on the control board will light on.
N ote 1: The below items will not display in error code, to check this items press and hold freezer temperature adjust button and
Ultra ice button for at least one second.
2-15 Test Function
1. The purpose of test function is to check function of the PWB and product and to search for the failure part at the failure
status.
2. Test button is placed on the main PCB of refrigerator (test switch), and the test mode will be finished after maximum 2
hours regardless of test mode and then is reset to the normal status.
3. In finishing test mode, always pull the power cord out and then plug-in it again for the normal state.
Always wait at least 3 minutes before restarting a compressor to allow the pressures to equalize and to avoid damage.
4. If nonconforming contents such as sensor failure are found during performance of test mode, release the test mode and
display the failure code.
NOTE: Test mode will not begin if an error code is
displayed.
NOTE: During the Test mode, display board buttons
will not operate.
After finishing the Test mode, always unplug and replug
in the refrigerator to reset to normal operation.
41°F (5°C)
Function
• Compressor on, Evaporator BLDC motor on
and Condenser BLDC motor on.
• Damper is completely opened.
• All display LEDs Graphics turns on. Evaporator fan turns off
if the door are open.
Press the button again,
to enter to Test 2.
• Compressor off, Evaporator BLDC motor off
and Condenser BLDC motor off.
• Defrost heater turn on.
• Damper is completely closed.
• All LEDS will be off except the lower three
refrigerator and freezer temperature indicator
lights.
Press the button again,
to return to Normal status.
Normal operation
Test button
Main PCB
Ultra Ice Select