14
REFRIGERATOR INSTALLATION
Left leveling
leg
Height
Height
difference
difference
PRESS & HOLD
CHANGE FILTER
C
F
C
F
Right leveling leg
Height
difference
Height
difference
PRESS & HOLD
CHANGE FILTER
C
F
C
F
Height
difference
Height
difference
PRESS & HOLD
CHANGE FILTER
C
F
C
F
Keeper nut
Adjustment
hinge pin
Wrench
Up
Down
LEVELING
After installing, plug the refrigerator’s power cord into a
3-prong grounded outlet and push the refrigerator into the
fi
nal position.
Your refrigerator has two front leveling legs—one on the
right and one on the left. Adjust the legs to alter the tilt
from front-to-back or side-to-side. If your refrigerator
seems unsteady, or you want the doors to close more
easily, adjust the refrigerator’s tilt using the instructions
below:
NOTE:
Tools Required:
11
/
1
6
” (18mm) wrench or
fl
at blade
screwdriver.
1.
Remove the base grille (refer to page 10).
2.
Turn the leveling leg counterclockwise to raise that side
of the refrigerator or clockwise to lower it. It may take
several turns of the leveling leg to adjust the tilt of the
refrigerator.
NOTE:
Having someone push backward against the top of
the refrigerator takes some weight o
ff
of the leveling legs.
This makes it easier to adjust the legs.
3.
Open both doors again and check to make sure that
they close easily. If the doors do not close easily, tilt
the refrigerator slightly more to the rear by turning
both leveling legs counterclockwise. It may take
several more turns, and you should turn both leveling
legs the same amount.
4.
Replace the base grille.
DOOR ALIGNMENT
If the doors are still uneven after the refrigerator has
been leveled,
fi
nish adjusting the doors by following the
instructions below.
Adjusting tools: 5/16” (8mm) wrench and 3/4” (19mm)
wrench
Using a 3/4” (19mm) wrench, turn the keeper nut
clockwise to loosen the keeper nut.
Using a 5/16” (8mm) wrench, turn the adjustment hinge
pin clockwise or counterclockwise to level the refrigerator
and freezer door.
After leveling the door, turn the keeper nut
counterclockwise to tighten. Make sure the front leveling
legs are complet
CAUTION:
Do not overtighten the door adjustment screw.
The hinge pin can be pulled out. (The adjustable range of
height is a maximum of 1/2” (1.27 cm).)
Содержание 795.5181
Страница 41: ...41 NOTES ...
Страница 81: ...121 NOTES ...
Страница 82: ...NOTES ...
Страница 83: ...NOTES ...