14
Setting Surface Controls
•
Operating the Bridge Radiant Surface Element Control
Operating the Bridge Element (some models)
The cooktop is equipped with a “BRIDGE” surface element located at the
left cooktop position (See Fig. 1). Indicator lights on the control panel are
used to indicate what portions of the Bridge element will heat. The Bridge
element begins with the left
FRONT
position only (Fig. 2) and when
selected with the
+BRIDGE
element (Fig. 3) it will provide a combination
of 2 heating surfaces. When set for
ALL
3 element positions the left rear
element is added for a total combination of 3 even heating surfaces (See
Fig. 4).
The Bridge element is designed for rectangular or oval shaped cookware.
The
griddle
that is supplied with this appliance
should be used with the
Bridge element ONLY
. For round shaped cookware, the left front
element may be used as a single element.
To Operate the Bridge Surface Element:
Radiant surface elements may appear to have cooled after they have been turned off.
The glass surface
may still be hot
and burns may occur if the glass surface is touched before it has cooled sufficiently.
Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or
plastic wrappings on top of the range when it is in use.
These items could melt or ignite. Potholders, towels or
wooden spoons could catch fire if placed too close to the surface elements.
1.
Place correctly sized cookware on the radiant surface element.
2.
Touch and hold the
pad for the Bridge element position until a beep
is heard. The display will show
" - - "
.
NOTE:
Each time a pad is touched a
beep will sound. If no further pads are touched within 10 seconds the
request to power the element ON will clear.
3.
Select the
FRONT
(See Fig. 2),
+BRIDGE
(See Fig. 3) or
ALL
3 elements
(See Fig. 4) to heat by pressing the
pad once, twice or three times
(Figs. 4 & 5 shows indicator lights with
ALL
3 elements selected).
4.
Touch the Bridge element
pad once to turn ON the power level
Hi
or
pad once for
Lo
(See Fig. 4). The
Hot Surface
indicator light will
turn ON when the element becomes hot.
5.
Each touch of the
or
pad will decrease or increase the power
level by 1/2 from
9.0
through
3.0
. Simmer power levels between
3.0
and
1.0
will decrease or increase by .2 increments.
Lo
is the lowest power level
available. Note: The power level may be adjusted at any time while the
element is ON.
6.
When cooking has been completed touch the
pad once to turn the
element OFF.
Each surface element provides a constant amount of heat at each setting. A
glowing red surface heating area extending beyond the bottom edge of the
cookware indicates the cookware is
too small
for the surface heating area.
Note:
The
Hot Surface
indicator light will remain ON if the cooktop is still hot and will remain ON until the heating
surface area has cooled sufficiently. If no element size is chosen when the Bridge element is turned ON, the control will
default to the left front element only. See page 11, Fig. 1 for recommended surface cooking settings.
NOTE: If all 3 Bridge elements are
selected, any previous power level
setting for the LEFT REAR element
will be changed to the power level
setting for the Bridge.
Fig. 3
Fig. 4
Fig. 1
Fig. 2
Fig. 5
Содержание 790 .9662
Страница 50: ...50 ...
