Kenmore 415.16644900, Инструкция по использованию и уходу

Страница: 23 / 32

13
Inside of cart, insert rear shield tabs into slots next to grease tray opening on upper back panel, shown A.
Attach front shield tabs(with holes) under front brace with two #8x3/8” self-tapping screws, shown B.
Tank heat shield
Cart lower back panel
Front Brace
#8x3/8”
#8x3/8”
self-tapping screw
self-tapping screw
Qty.2
for clarity of illustration
Note: some parts omitted
B
Upper back panel
Grease tray opening
rear tab
front tab
(w/hole)
Rear
Front
Tank heat shield
A
14
464222009 • 23
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module. Total (5) connections, shown A.
Connect the two wires [(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).
Total (2) connections, shown A.
ignition module
Electronic
Heat shield
Left side panel
B
C
Release the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to the cart left
side panel with the nut, shown B.
Insert AA battery into ignition module, negative (
-
) end first. Then put on the cap, shown C.
Nut
-
+
AA battery Cap
3
1
2
4
5
(a)
(b)
ignition module
Electronic
A