11
If the unit is to be placed outside of the room to be cooled, you should try to position the unit on a
flat solid surface and in an area protected from rain and sun exposure such as sunroom, veranda
or hallway. You should not operate the unit in moist areas, such as e.g. saunas or similar areas.
The colour of the unit can change slightly due to direct solar radiation.
The unit is equipped with a special thermal deactivation. This protects the unit from overheating in
extreme ambient conditions.
Please place the unit so that the air inlet is not impeded, e.g. by furniture or curtains, since this can
negatively effect the capacity.
Place the unit in the shade if possible and in a cool place in order to increase efficiency and to avoid
overheating. If the ambient temperature is over 32°C the unit may shut down. If this occurs repeatedly, we
recommend moving the unit to a cooler location out of direct sunlight.
RECIEVER INSTALLATION
To enable operation of the remote control while the machine is not in the room being cooled, you must install
the remote sensor that came with the unit. The remote sensor is placed in the window kit.
1) Remove the plastic cover from the small hole in the window kit. Keep it for later use.
2) Position the remote sensor from the rear of the window kit (outside the room being cooled), by pushing it
into the hole. The sensor must face the room being cooled and be positioned above the air outlet.
3) Remove the plastic cover from the remote sensor jack on the main body of the unit, found near the top
of the front of the unit. Keep it for later use.
4) Attach the end of the supplied cable to the jack on the main unit. Organize the wire so it will not get
damaged, stepped on or pinched.
When using the remote to control the unit, point the remote to the receiver installed on the window kit, when
the remote signal received by the main unit, a green LED on the receiver will flash. DO NOT BLOCK THE
RECEIVER, THE ROOM TEMPERATURE SENSOR IS ALSO IN THIS RECEIVER.
Set the function to “COOLING“. The target temperature can range between 17°C and 30°C (65°F and
90°F).
Make sure that no warm outside air can enter the room. You can also control the unit from inside using the
remote control, aimed at the sensor on the window kit.
HEATING MODE ***
UNIT MUST BE USED IN ROOM FOR HEAT MODE
***
On cold days it is recommendable to start the unit early in order to get a warm room.
The heating function of the unit must not be operated at a room temperature less than 15°C.
Disassemble the subassembly of outlet and the subassembly of exhaust pipe as arrow direction Fig.01 and
then exchange the two subassemblies to install. The finished illustration is as Fig.03.
Connect the air hose and the air outlet grid to the unit as displayed in the illustration. The hose must be
connected to the side with the COOL icon [
].
