4
WARNING: To reduce the risk of electric shock,
disconnect from power supply before cleaning.
Aluminum mesh
fi
lters
Clean frequently using hot water and a mild detergent or in
your dishwasher. The aluminum mesh
fi
lter should be washed
approximately every month depending on the amount of
usage. Wash more often if your cooking style generates
greater grease - like frying foods or wok cooking.
Non-ducted recirculation
fi
lters
(available separately - see page 5)
The non-ducted recirculation
fi
lters should be changed
every 3 to 6 months. Replace more often if your cooking
style generates extra grease, such as frying and wok
cooking. Refer to installation instructions included with
non-ducted recirculation
fi
lters.
Painted hood surfaces
Clean with warm water and mild detergent only. If
discoloration occurs, use a
fi
nish polish such as automotive
polish. (DO NOT use rough abrasive cleaner or porcelain
cleaner.)
Stainless steel hood surfaces
Do:
• Regularly wash with clean cloth or rag soaked with
warm water and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after
cleaning. Wipe dry completely.
• You may also use a specialized household stainless
steel cleaner.
Don’t:
• Use any steel or stainless steel wool or any other
scrapers to remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues
reach the hood. During construction/renovation, cover
the range hood to make sure no dust sticks to the
stainless steel surface.
Avoid when choosing a detergent:
• Any cleaners that contain bleach will attack stainless
steel.
• Any products containing:
chloride,
fl
uoride, iodide,
bromide
will deteriorate surfaces rapidly.
• Any combustible products used for cleaning such as
acetone, alcohol, ether, benzol
, etc., are highly explosive
and should never be used close to a range.
Fan assembly
The fan blade should be cleaned frequently. Use a clean
cloth soaked with warm detergent solution.
The motor is permanently lubricated and never needs
oiling. If the motor bearings make excessive or unusual
noise, replace the motor with the exact service motor. The
fan blade should also be replaced.
CLEANING
Fan
This rocker switch (on the left) controls the fan. See below:
Light
This rocker switch (on the right) controls the light. See below:
OPERATION
FAN
SWITCH
LIGHT
SWITCH
I
Turns fan on to LOW speed.
•
Turns fan OFF.
II
Turns fan on to HIGH speed.
I
Turns light on to LOW intensity.
•
Turns light OFF.
II
Turns light on to HIGH intensity.
