13
REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use, vacation, winter storage,
or moving:
1.
Refer to Installation Instructions to locate, level, and
connect washer�
2.
Before using again, run washer through the following
recommended procedure:
To use washer again:
1.
Flush water pipes and hoses� Reconnect water inlet hoses�
Turn on both water faucets�
2.
Plug in washer or reconnect power�
3.
Run washer through Bulky/Bedding cycle to clean washer
and remove antifreeze, if used. Use only HE High Efficiency
detergent. Use half the manufacturer’s recommended
amount for a medium-size load�
TRANSPORTING YOUR WASHER
1.
Shut off both water faucets. Disconnect and drain water
inlet hoses�
2.
If washer will be moved during freezing weather, follow
“Winter Storage Care” directions before moving�
3.
Disconnect drain hose from drain system�
4.
Unplug power cord�
5.
Place inlet hoses inside washer basket�
6.
Drape power cord and drain hose over the console and
secure with masking tape�
7.
Place foam packing ring from original shipping materials
back inside washer� If you do not have packing ring, place
heavy blankets or towels into basket opening� Close lid
and place tape over lid and down front of washer� Keep
lid taped until washer is placed in new location� Transport
washer in upright position�
WINTER STORAGE CARE
IMPORTANT:
To avoid damage, install and store washer
where it will not freeze� Because some water may stay in
hoses, freezing can damage washer� If storing or moving
during freezing weather, winterize your washer�
To winterize washer:
1.
Shut off both water faucets; disconnect and drain water
inlet hoses�
2.
Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run
washer on Rinse & Spin cycle for about 30 seconds
to mix antifreeze and remaining water.
3.
Unplug washer or disconnect power�
CLEANING YOUR DISPENSER
IMPORTANT:
Dispenser drawer and tray are not dishwasher
safe�
You may find laundry product residue left over in your dispenser
drawer� To remove residue, follow this recommended cleaning
procedure:
1.
Pull drawer out until you feel resistance�
2.
Push 2 tabs downward, then continue pulling out�
3.
Wash in warm, soapy water, using a mild detergent�
4.
Rinse with warm water�
5.
Air dry or dry with a towel, then place back into slot�
Содержание 110.28132411
Страница 21: ...21 ...
Страница 41: ...41 ...
Страница 60: ... W11040361A 2017 Sears Brands LLC 01 17 ...