11
Ice Maker Door Reversal—Side Swing Only
Tools Needed
Gather the required tools and parts before starting installation.
Remove Exterior Door Wrap and Handle
(on some models)
1. Remove the handle screws and handle (on some models).
2. Remove the 2 hex-head screws located under the stainless
steel door wrap panel flange on the bottom of the door.
3. Pull up and outward on the door wrap panel from the
bottom.
4. Rotate the door wrap panel until it separates from the door
and pull up.
NOTE: Be sure the edge guards do not separate from the
door wrap panel.
Door Stop and End-Cap Reversal
1. Unplug the ice maker or disconnect power.
2. Remove the hinge pin from the top hinge.
Top Hinge
Bottom Hinge
■
⁵⁄₁₆
" wrench
■
Flat putty knife
■
¹⁄₄
" wrench
■
Phillips screwdriver
Hinge pin
⁵⁄₁₆
" hex-head hinge screw
Handle screw
End cap screw
A. Hex-head screws
A
A. Hinge pin
B. Phillips-head countersink screw
C. Door stop
D. Hinge
E. Hex-head hinge screw
A. Hex-head hinge screw
B. Door stop
C. Phillips-head countersink screw
D. Hinge pin
E. Hinge
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
A
C
D
E
B
A
B
E
D
C
