Kendro HERAcell 150, Руководство по эксплуатации

Страница: 29 / 251

CO
2
Incubator HERAcell ® 150 Operating Instructions
29
5. Start-up
5.1 Preparing the work space
The incubator is not delivered in a sterile state. Before the initial
start-up, the device must be decontaminated.
Before the decontamination is performed, the following work
space components must be cleaned:
• Support rails,
• support hooks,
• shelves,
• gas humidification,
• work space surfaces,
• work space seals and gaskets,
• glass door
NOTE – Decontamination
For details about the cleaning and disinfection
of the device, see Section 9.
5.2 Installing the shelf system
Tools are not required for the installation of the shelf system.
The support rails are secured using spring pressure. After the
support hooks have been inserted into the rail, the shelves are
pushed onto the support hooks.
Support rail installation/removal:
Fig. 13:
The support rails are held at the sides by the embos-
sings [2] and [5] and secured by the embossings [1] and [6].
The support rails marked with ( ) are inserted at the rear pa-
nel of the device with the locksprings [3] facing upward.
1. Position support rail [4] onto lower embossing [6] and tilt
toward the work space side wall so that the rail is positio-
ned over the two embossings [5] and [2].
2. Clamp lockspring [3] behind upper embossing [1].
3. To remove the support rails, pull lockspring tab down out
of the embossing and remove rail.
Fig. 13
Support rail installation/
removal
1
2
4
5
1
6
5
6