Kendrion Kuhnke Automation GmbH
Accessories
449
17 May 2021
6.2 Shield Terminal
Shield terminal 1x14mm
Dimensions
Shield terminal 2x8mm
Dimensions
Terminals
The shield terminal assembly consists of the actual shield terminal, the
terminal bracket, tweo M3x5 screws, 2 washers, and 2 spring washers.
Use the 2 screws, washers and spring washers to mount the terminal
bracket on the housing mount of the Kuhnke FIO module.
Screw the screws into the 2 holes tapped into the bottom of the front side.
Function
The shield terminal makes it easier for you to connect the cable shield. The terminal deflects the cable shield
power to the DIN rails that the Kuhnke FIO module is snapped on to.
NOTE
Verify that the DIN rail is properly earthed.
NOTE
Do not use the shield terminals as a strain relief.