background image

 

The obligation of 

the Manufacturer/Distributor

 under this Limited Warranty is limited to repairing or 

replacing, at 

the Manufacturer/Distributor

 sole discretion, any part of the product which is defective 

and is covered by the terms of this Limited Warranty. If any covered defect occurs during the warranty 
period call 

1-800-536-2683 

for instructions. Replacement or repair will be without cost to you other than 

shipping cost to repair site. The remedies set forth in this paragraph are your only remedies for any 
defects, failures or malfunctions of the product.

 

 
The date of manufacture will be used to determine warranty period if no warranty card has been 
returned. If you have any questions about the terms of this Limited Warranty, you may write 

KENCOVE Farm Fence Inc.; 344 Kendall Lane; Blairsville, PA 15717 

or call 

1-800-536-2683

 

 
Damages caused directly or indirectly by batteries of any kind, over-voltage or out-treading acid are 
excluded from any warranty. 

 
 

LIMITATION OF DAMAGES

 

The directions for use of this product must be followed carefully. The effectiveness of fence controllers 
may depend on the effectiveness of connections, interruption of power source, accidental grounding of 
wires, weather conditions, or manner of use or application, all of which are beyond the control of 

the 

Manufacturer/Distributor

 or the Seller. All such risks shall be assumed by 

the Buyer

The 

Manufacturer/Distributor

 and the Seller offer this product and 

the Buyer

 and user accept it, subject to the 

foregoing conditions of sale and warranty which may be varied only by written agreement signed by an 
officer of 

the Manufacturer/Distributor

.

 

 

 Possible sources of errors: 

(Figure 2)

 

 

Pos.  Sources of errors 

Debugging 

Derivative due to growth at the fence! 

Remove growth (mow / cut)! 

Bad grounding, grounding rod too 
short, rust, dry ground! 

Drive in the grounding rod completely! Use several 
long grounding rods and connect them with each 
other! 

Conductive material lying on the ground
(e.g.: tape / wire break, not stretched)! 

Repair fence, stretch conductive material! 

Conductive material is of bad quality  
(thin conduction wire, high resistance) 

Use high-quality conductors with low resistance and 
thick conduction wires. In case of wide tapes, pay 
attention to the splices! 

Conductive material knotted! 

Use corresponding special-connectors for wire 

tape / rope! 

Insulator leaks current! 

Exchange damaged and weather-beaten insulators! 

Derivative or short circuit in the fence 
wire! 

Never use an ordinary moisture resistant cable or 
something like this for connection! 
Always use high voltage cable! 

Fence is too long! 
Has the right appliance been chosen 
for this use? 

 
Use the right energizer corresponding to the length of 
the fence and to the type of animal – if necessary, 
discuss it with your specialist dealer. 

Does the electric fence energizer work?

Disconnect the energizer from the fence and then 
switch it on! If the LED blinks, the appliance is okay, 
if it does not, the appliance is damaged (contact your 
specialist dealer)! Pay attention to the polarity of the 
batteries! 

Содержание AG M4








Отзывы: