www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United Stateswith more than 50% of the component cost of US origin It may be covered by patents
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
2
INSTALLATION INSTRUCTIONS
MPWV _F-1875_090418
3. Locate and drill pilot holes in mounting surface using baseplate as template. Note that baseplate is not
universal and should be mounted with lens brackets up. Using six (6) #10 screws (supplied), mount baseplate
to surface. Fixture should be mounted to surface with 6-point mounting. Do not mount fixture from electrical
junction box. NOTE: to comply with OSHPD certification for this fixture, see wall structure and mounting
specifications at the end of this document. When installed according to those instructions, the product will
meet California Building Code requirements for seismic anchorage, as required by OSHPD (California ‘s Office of
Statewide Health Planning and Development).
4. If low voltage controller option was ordered, refer to included supplemental wiring instructions.
5. In all cases, grounding wire(s) must be connected to a suitable ground.
6. Connect quick connect leads to power supply leads using connectors suitable for the gage and number of
wires being used (not included). Black and/or other colored leads connect to the supply conductor and white
lead(s) connect to the neutral supply conductor. Connections are to be made in the junction box, not the fixture.
Connect quick connect(s). Install electrical assembly and secure using two thumb nuts. Install lamps (supplied
by others). Slide valance over baseplate and secure with two set screws.
