Flexlite TX
Operating manual - EN
3.2 Installing torch remote
You can install a torch remote on a K5 level torch only.
Many Flexlite TX welding torches are equipped as standard with ON/OFF start/stop switches. Optional remote control
devices can be fitted to these TX torch models, allowing both start/stop function and welding current adjustment.
Ensure that the welding equipment is not connected to the mains or that the welding torch is not connected to the
welding machine at this stage.
1.
Open the switch cover by releasing the screws in the rear section of the cover and remove the cover.
2.
Take the existing circuit board out of its slot in the handle and unplug the connector.
© Kemppi
10
1920910 / 2039
