38
Copyright © 2000 - 2005 KEMP Technologies, Inc. All Rights Reserved.
The format of the input is the same as used for eth0. If an address is given, then this must be on a different
network to the address(s) on eth0.
Hostname(s)
The hostname of the LoadMaster must now be set. A standard (or previously set) name is suggested. This
name does not need to be changed unless the LoadMaster is to be part of a HA cluster and is to be installed
on the same broadcast network as other LoadMaster clusters.
When configuring a LoadMaster HA cluster, the name of the partner machine is requested, a standard name is
also suggested here. This name also does not need to be changed unless the configuration requires it.
DNS configuration
The DNS resolver is now configured. Up to three DNS servers may be specified (Addresses must be in “dotted
quad” syntax).
A list of search domains can now be given. Up to 6 domains can be specified.
E. Main Menu
Many features of the LoadMaster can be configured using the menu system. The menu system can be used by
logging onto the console as “bal”, or by remotely logging into the system using the SSH protocol.
Important: Remote access is only permitted if the SSH service is enabled and the password for “bal” has
been changed from its default value. If the password has not been changed from its default value, the user
“bal” will only be allowed to login from a directly connected console.
Note: If the password for “bal” has been forgotten, a user can login on the console as pwreset. The
password is 1pwreset, this will reset the password for “bal” to 1fourall until the LoadMaster is rebooted. If
unit is rebooted the password will be reset to its old (unknown) value. It is thus strongly advised that the
password should be changed using the configuration menu before the next reboot.
1. Configuration Menu basics
The configuration menu system is made up of a number of hierarchical menus split into functional groups.
Navigation around the menus can be performed by using the Up and Down cursor keys, or by using the “+”
and “-“ keys. On menus with numeric entries, the number can also be given.
Example: To change the keyboard mapping, the user can type 3<CR> - which selects the
“Local Administration” menu, followed by 3<CR> for “set keyboard map”.
Using “q”<CR> or “ESCAPE” or using the [CANCEL] button will return the user to the previous menu.
Hint: To access the [OK], and [CANCEL] buttons, use the TAB key to toggle between the menu and the
buttons.
Using the [CANCEL] button from the main menu, all changes made to the configuration will be ignored.
Using the [OK] button from the main menu performs the menu point, which is currently highlighted.
Important: When the LoadMaster is configured in a HA cluster, and the user is logged onto the standby
machine, only the configuration of the local IP interfaces, changing the local password and performing a
backup/restore should be performed, all other configuration parameters should only be changed on the active
machine. From the main menu, the following options are available.
