Kemot URZ3353, Руководство пользователя

Страница: 11 / 24

Owner’s manual
11
EN
Operation
Note: Make sure the product is fully assembled before plugging it into power supply
socket.
1. Place the fan on a flat stable surface.
2. Plug the fan into power mains.
3.
If you want to adjust the height of the fan you can loosen the height adjustment
knob and adjust the pipe to the desired height and then fasten it.
• Setting the speed and turning off the fan
Press Power button on the control panel of the fan or On button on the remote
control to turn on the device. Press Speed +/- buttons to adjust the speed of the
fan. Press Power button on the control panel of the fan again or Off button on
the remote to turn off the fan.
• Activating and deactivating oscillation
When the fan is on, press Swing button on the control panel of the fan or on the
remote control to turn on the oscillation. Press this button again to turn off the
function.
• Mode selection
Press Mode button on the control panel of the fan or on the remote control to
switch between 3 available modes: NORMAL, NATURAL and SLEEP.
• Normal: normal mode of fan operation.
• Natural: simulation of air flow under natural conditions.
•
Sleep: in this mode, fan gradually decreases and increases speed. Too strong
wind during sleep could lead to colds.
• Setting the timer
Press Timer button on the control panel of the fan or on the remote control to set
the time of device turn off from 0,5 to 7,5 h in half-hour interval.
4. To adjust the tilt angle, grab and tilt the motor housing up or down to the desired
angle.
Cleaning and maintenance
1. Prior to cleaning, disconnect the device from power mains.
2. Clean this device with soft, slightly damp cloth. Do not use any chemical agents
to clean the fan.
3. Dry the fan with a dry cloth after cleaning.
Troubleshooting
When the fan is on and the blades do not work, please check the connection to
power supply socket. When there are noises while operating the fan, please check
if: