25/02/2021
Ver. 1
7
• Eyelets on the unit are supplied for attaching a turn buckle system,
6-8mm threaded rod is required with a nut and washer either side
of a sufficient supporting roof member. Alternatively, a stainless
steel wire with a minimum 1mm diameter or heavier and a
minimum break load of 130kg can also be used.
• Once hooks have been attached to the eyelets the turn buckle can
then be simply wound up to take the tension.
• Tighten the turn buckle until both the top and bottom glass runners
are parallel.
• Removable glass panel can now be placed in position allowing an
even gap between glass and underside of channel.
EYELET
MAKE SURE THESE
PLANES ARE PARALLEL,
AND MAKE SURE ALL
CORNERS ARE SQUARE
THREADED ROD
DRILL THROUGH THE
BEAM , RAFTER OR
FRAMING IF REQUIRED
AND PUSH THROUGH
THE THREADED ROD.
Installation Instructions Kemlan Three Sided Natural Draft
Electronic Ignition Gas Fireplaces
