Kelvinator KSV25HWJ, Руководство пользователя, Страница: 7 / 26

7
Handling the Remote Controller
Battery Notes
Battery Disposal
Handling the Remote Controller
Inserting and Replacing Batteries
Your air conditioning unit may come with two batteries(some
units). Put the batteries in the remote control before use.
1. Slide the back cover from the remote control downward,
exposing the battery compartment.
2. Insert the batteries, paying attention to match up the (+)
and (-) ends of the batteries with the symbols inside the
battery compartment.
3. Slide the battery cover back into place.
For optimum product performance:
Do not mix old and new batteries, or batteries of
different types.
Do not leave batteries in the remote control if you don’t
plan on using the device for more than 2 months.
Do not dispose of batteries as unsorted municipal waste.
Refer to local laws for proper disposal of batteries.
NOTES FOR USING REMOTE CONTROL
The device could comply with the local national regulations.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications not approved by the party
responsible for compliance could void user’s authority to
operate the equipment.
TIPS FOR USING REMOTE CONTROL
The remote control must be used within 8 meters of the unit.
The unit will beep when remote signal is received.
Curtains, other materials and direct sunlight can interfere
with the infrared signal receiver.
Remove batteries if the remote will not be used more than 2
months.