Kelvinator KGC20BL Series, Руководство пользователя

Страница: 4 / 16

4 important safety instructions Kelvinator gas continuous flow hot water system
FLAMMABLES
FLAMMABLE VAPOURS
warning
The water heater shall be installed so as to be permanently
connected to the water mains with rigid copper piping and
must not be connected by a flexible hose-set or similar
Safety before operating
warning
For your safety, please read before operating
• Check the
GAS
and
WATER CONNECTIONS
for leaks
before using it for the first time.
• Be sure to check next to the bottom of the water heater
because some gases are heavier than air and may settle
towards the floor.
• Open the main gas supply valve to the water heater
using only your hand to avoid any spark. Never use tools.
If the knob will not turn by hand, do not try to force it; call
a qualified service technician. Forced repair may result in
a fire or explosion due to gas leaks.
• Do not try to light the burner manually. It is equipped with
an electronic ignition device which automatically lights
the burner.
• Check for PROPER VENTING and COMBUSTIBLE AIR to
the heater.
• Do not use this water heater if any part has been
submersed in water. Immediately call a qualified service
technician to inspect the water heater and to replace any
damaged parts.
• If this water heater is a 70°C model installed as part of
a gas boosted solar hot water system, please refer to
the user manual supplied with that system for safety
regarding the relief valves installed to limit temperature,
pressure and energy.
Ensure the following safety instructions are read and
understood before using this water heater.
warning
Water temperatures above 50°C can cause severe burns,
scalding or death. Feel the water temperature before
bathing or showering. Do not leave children unsupervised.
The Australian Standards AS3498 provides full details of
the requirements for the supply of controlled temperatures
to bathrooms and is required to be conformed to under all
Australian plumbing codes.
• Do not store or use gasoline or other flammables,
vapours or liquids in the vicinity of the gas continuous
flow hot water system.
• Do not reverse the water and/or gas connections as this
will cause damage to the gas valves, and may also cause
severe injury or death.
• Do not use this water heater if it has at any stage been
immersed in water. Immediately call a licensed plumber,
gas fitter or authorized technician to inspect and/or
service the system.
• Do not disconnect the electrical supply if the ambient
temperature drops below freezing. The Freeze Protection
System only works when the water heater is connected to
the power. The warranty is void if the heat exchanger is
damaged as a result of freezing.
• This hot water system is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the hot water system by a person
responsible for their safety.
• Children should be supervised to ensure that they do not
play with the hot water system.
• This hot water system is equipped with an ignition device.
Do not try and light the burner manually.
• Prior to operating ensure that there is no evidence of
leaking gas.
warning
Vapours from flammable liquids will explode and catch fire
causing death or severe burns.
Do not use or store flammable products such as gasoline,
solvents or adhesives near the water heater.
Keep flammable products:
1. Far away from the water heater
2. In approved containers
3. Tightly closed
4. Out of children's reach
Vapours:
1. Cannot be seen
2. Vapours are heavier than air
3. Go a long way on the floor
4. Can be carried from other rooms to the main burner by
air currents
Important safety instructions