Kellyco GOLD FINDER, Руководство пользователя

Страница: 10 / 24

Assemble the detector per instructions on page 1.
Insert the batteries correctly (+/- polarity).
Rotate the Off/Volume switch clockwise to turn on the metal detector. This switch also
adjusts the volume. Immediately after turning detector on, the metal detector will
emit beep(s) indicating the battery life status.
Select the Mode.
Adjust the DISC. FILTER, SENSITIVITY and iSAT/iMASK switches to their default
positions (highlighted numbers) on the control panel.
Auto ground balance: Depress and hold the rotary GROUND BALANCE multi-function
switch and repeatedly pump the search coil up and down 3cm - 10cm (1 - 4") above
the ground until detector emits a “beep” sound.
If ALL METAL mode is selected, adjust the THRESHOLD to a level where you can still
hear the small nugget signals. If the metal detector receives a lot of ground noise in
the ALL METAL mode causing a disruption in the threshold's stability, gradually
increase iSAT value until metal detector stabilizes.
Mask/elimination of undesirable targets: When using discrimination modes (DISC.1 or
DISC.2) you can eliminate (Mask) the metal detector response to undesirable targets
by adjusting the DISC. FILTER value. As an example, if you are searching a trashy area
filled with undesirable ferrous objects (nails) and would like to eliminate (Mask) the
detector response for the undesirable target, simply sweep the detector over the
target noting the response. While sweeping the detector over the target, gradually
adjust the DISC.FILTER while continuing to sweep the detector until the Au GOLD
FINDER is no longer emitting a response tone when sweeping over the target.
Sensitivity: Increasing detector sensitivity provides greater detection depth but also
increases the potential instability of the detector due to high mineralization, electrical,
radio frequency (RF) or electromagnetic interference. Reduce sensitivity when local
environment or mineralization causes excessive noise, instability, overload and/or
interferes with the optimal performance of the detector.
Tone Familiarization: Testing the detector with various metal targets using DISC.1 and
DISC.2 is useful for learning the relationship between tone and specific targets.
The
Au GOLD FINDER operates on the motion principle: If the search coil is not
moving, the Au GOLD FINDER will not detect targets even if the coil is directly over a
metal target. Sweep the search coil alternately right and left maintaining level coil at
approximately 5cm (2") distance above the ground. Sweep speed should be 1.5 - 2
seconds (side to side). Sweeping the detector faster or slower than recommended
sweep speed will notably diminish the performance of the detector.
Time to begin detecting!
1
2
3
4
5
6
7
8
9
10
11
12
Quick Guide
Page 7