Kellfri 21-SV500E, Руководство пользователя

Страница: 13 / 36

13
Table of contents
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE MEASURE
The blade teeth are torn from
the band 1. Wrong type of saw blade
2. Incorrect feeding rate
3. The stock is loose
4. Teeth are filled with chips / dirt 1. Replace band saw blade, use only the
recommended band saw blade
2. Adjust speed
3. Ensure that the log is fixed on the rails,
ensure that the log is free from branches
4. Clear band saw blade from chips / dirt
The sawmill cuts too slow 1. Wrong type of blade
2. Incorrect feeding rate
3. The log is loose
4. Teeth are filled with chips / dirt 1. Replace band saw blade
2. Remove the belt, the teeth must be
facing the rails
The mill vibrates too much 1. The log does not sit firmly on the rails
2. The belt is deformed
3. Wheel axle bearings are worn
4. The carriage is pushed forward too fast
5. Loose Bolts 1. Ensure that the log is securely attached
on the rail before operation
2. Replace belts
3. Check and replace the wheel bearings
if necessary
4. Reduce forward speed
5. Check all bolts and tighten if necessary
The machine cuts conical or
thinner in the end The rail is not straight 1. Check that the rail is straight. Make
sure that the sawmill is placed on a flat,
hard surface.